MULTIPLEX Dual Transformer Installation guide

Brand: MULTIPLEX

Model: Dual Transformer

Type: Installation guide

In accordance with our policy of continuous product development and improvement,

this information is subject to change at any time without notice.

EI214014

11/01/06 REV 4

Manitowoc Beverage Equipment

2100 Future Drive  Sellersburg, IN 47172-1868

Tel: 812.246.7000, 800.367.4233  Fax: 812.246.9922

www.manitowocbeverage.com

RESET SWITCH

Multiplex Beverage Equipment Installation Instructions for

Dual Transformer Assembly

P.N. 00214014

INTRODUCTION

Tools Needed

 Electric Drill with

/32" (23 mm) Bit (0.156 diameter)

 Screwdriver.

General

1. Determine convenient location for mounting transformer.

2. Assembly 00214014 requires 115 VAC receptacle within 6 ft

(1.8 m) of transformer.

3. Transformer must be within 6 ft (1.8 m) of dispensing tower.

4. Screws are provided for mounting on sheet metal surface.

Note: Mounting may be in any position. However, consider-

ation should be give to service access because the transform-

ers have built in circuit breakers.

INSTALLATION

1. Position transformer temporarily in desired location and

mark mounting hole locations.

2. Center punch the hole positions and drill two (2)

/32"

(23 mm) holes.

3. Place transformer assembly in position and secure with

two (2) #10 screws provided.

4. Plug dispensing tower into secondary lead cord recep-

tacles. Plug transformer power supply cord into recep-

tacle.

CAUTION: TO AVOID SERIOUS INJURY

Important: Read the following warnings before beginning an installation. Failure to do so

may result in possible death or serious injury.

DO Adhere to all National and Local Plumbing and Electrical Safety Codes.

DO Unplug incoming electrical service when servicing, installing, or repairing equipment.

MULTIPLEX Dual Transformer Installation guide

MULTIPLEX Dual Transformer Installation guide

MULTIPLEX Dual Transformer Installation guide

Related papers

Other documents