NEC NP-PA703UL Installation guide

NP-PA703UL
NEC
Brand
NEC
Model
NP-PA703UL
Category
Projector mounts
Type
Installation guide
1
2015-06-17 #:056-9083-1
50 lb
(22.7 kg)
MAX
PA600CM
Ceiling Mount for NEC NP1150, NP2150, NP3150, NP3151W, NP1250, NP2250,
NP3250, NP3250W, NP-PA500U, NP-PA500X, NP-PA600X, NP-PA550W, NP-P502WL, NP-P502HL, NP-PA521U,
NP-PA571W, NP-PA621X, NP-PA622U, NP-PA672W, and NP-PA722X Projectors
NEC Display Solutions of America, Inc.
Compatible
model/series*
ENG
AEC*,
ALU*,
EXT*,
SCP200
2
2015-06-17 #:056-9083-1
ENG - This product is designed to be installed on wood joist/beam or solid concrete ceilings. Hardware is
included for wood joist/beam and solid concrete installation. Before installing make sure the supporting surface
will support the combined load of the equipment and hardware. Screws must be tightly secured. Do not
overtighten screws or damage can occur and product may fail. Never exceed the Maximum Load Capacity.
Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This product is
intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury. Be
careful not to pinch ngers when operating the mount. For support please call customer care at 1-800-865-2112.
WARNING
Symbols
ENG
WARNING
ENG
#
Skip to step.
ENG
x3
Screws must get at least three
full turns and t snug.
ENG
Front of mount.
ENG
F
Do not overtighten screws.
ENG
3
2015-06-17 #:056-9083-1
5/32"
(4mm)
5/16"
(8mm)
Tools Needed for Assembly.
ENG
1
2
ENG
To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
+1/2
4
3
3/8"
(10mm)
4
2015-06-17 #:056-9083-1
Parts (Before beginning, make sure you have all parts shown below).
ENG
Parts List
Part #Description Qty
A projector mount assembly 1 054-2171
B connection block 1 580-4400
C 4 mm security allen wrench 1 560-9646
D concrete anchor 2 590-0320
E #14 x 2.5 phillips hex head wood screw 2 5S1-015-C04
F #10-32 x 3/8" serrated socket pin screw 2 520-2151
G #10-32 x 1/4" socket pin screw 1 520-2196
H at washer 2 540-2078
I 2 mm security allen wrench 1 560-1097
J adapter plate 1 055-2999
K M4 x 25 mm serrated socket pin screw 4 510-2082
L spacer 4 590-2106
A
(
1
)
projector mount assembly
D
(
2
)
8mm concrete anchor
E
(
2
)
#14 x 2-1/2" wood screw
H
(
2
)
washer
G
(
1
)
#10-32 1/4"
F
(
2
)
#10-32 x 3/8"
I (1)
2mm security
allen wrench
C (1)
4mm security
allen wrench
B
(
1
)
connection block
J
(
1
)
adapter plate
K
(
4
)
M4 x 25mm
L
(
4
)
spacer
5
2015-06-17 #:056-9083-1
1
2a
Wood joist/beam
ENG
2c
Concrete Ceiling
ENG
2b-1
Extension Column (not included)
ENG
6
2015-06-17 #:056-9083-1
2a-1
2a-2
Mark mounting holes on stud center lines.
ENG
Use stud nder to locate and
mark stud center lines.
ENG
A
ENG - When installing Peerless ceiling mounts on a wood joist/beam covered with gypsum board (drywall), verify
that the joists or beams are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8".
WARNING
2a
7
2015-06-17 #:056-9083-1
2a-3
5/32"
(4mm)
2a-4
Drill mounting holes into supporting surface
(2.5" (64 mm) minimum depth required).
ENG
Install using wood screws provided.
ENG
Mounting hole must center
on stud.
ENG
2.5"
(64mm)
5/32"
(4mm)
Maximum 80 in-lb (9 N.M).
ENG
WOOD JOISTWOOD JOIST
A
H (2)
E (2)
ACCESS SLOT FOR
OPEN END WRENCH
ALLOWS TIGHTENING
OF WOOD SCREW (E).
ACCESS SLOT FOR
OPEN END WRENCH
ALLOWS TIGHTENING
OF WOOD SCREW (E).
H (2)
E (2)
A
3
8
2015-06-17 #:056-9083-1
2b-1
2b-2
2b-3
3
Loosen.
ENG
Tighten.
ENG
A
C
C
Rotate mount at least three full turns onto UL listed EXT, AEC or ALU
series extension column (sold separately).
ENG
9
2015-06-17 #:056-9083-1
2c
ENG - When installing Peerless ceiling mounts on a concrete ceiling, the ceiling must be at least 8" thick with a
minimum compressive strength of 2000 psi. Never attach concrete expansion anchors to concrete covered with
plaster, drywall, or other nishing material.
WARNING
2c-1
Mark mounting holes.
ENG
2c-2
5/16"
(8mm)
Drill mounting holes into supporting surface (2.5" (64 mm)
minimum depth required).
ENG
2.5"
(64mm)
5/16"
(8mm)
A
ARROW ON TOP OF
PROJECTOR MOUNT
ASSMEBLY INDICATES
FRONT OF MOUNT.
10
2015-06-17 #:056-9083-1
2b-42c-4
Install using concrete anchors and wood screws provided.
ENG
Maximum 80 in. ∙ lb (9 N.M.).
ENG
2c-3
D (2)
Insert anchor ush to concrete.
ENG
D
A
H (2)
E (2)
3
11
2015-06-17 #:056-9083-1
C
3
F (2)
B
J
Note proper orientation of notch.
ENG
3-1
K (4)
L (4)
C
12
2015-06-17 #:056-9083-1
Optional security screw.
ENG
4-2
4-3
G
4-1
F
F
C
Tighten.
ENG
13
2015-06-17 #:056-9083-1
5
Cable management: adjust pitch then route cables as shown.
ENG
Loosen.
ENG
Retighten.
ENG
+/- 5°
6-1
C
C
Loosen, adjust, tighten.
ENG
14
2015-06-17 #:056-9083-1
-15°
+20°
+/- 10°
-20°
+15°
F
6-3
Loosen, adjust, tighten.
ENG
3/8"
(10mm)
6-2
C
C
Loosen, adjust, tighten.
ENG
F
15
2015-06-17 #:056-9083-1
Peerless Industries, Inc. (“Peerless”) warrants to original end-users of Peerless
®
products will be free from defects in material and
workmanship, under normal use, for a period of ve years from the date of purchase by the original end-user (but in no case longer than
six years after the date of the product's manufacture). At its option, Peerless will repair or replace, or refund the purchase price of, any
product which fails to conform with this warranty.
In no event shall the duration of any implied warranty of merchantability or tness for a particular purpose be longer than the
period of the applicable express warranty set forth above. Some states do not allow limitations on how long a implied warranty lasts,
so the above limitation may not apply to you.
This warranty does not cover damage caused by (a) service or repairs by the customer or a person who is not authorized for such service
or repairs by Peerless, (b) the failure to utilize proper packing when returning the product, (c) incorrect installation or the failure to follow
Peerless' instructions or warnings when installing, using or storing the product, or (d) misuse or accident, in transit or otherwise, including
in cases of third party actions and force majeure.
In no event shall Peerless be liable for incidental or consequential damages or damages arising from the theft of any product,
whether or not secured by a security device which may be included with the Peerless
®
product. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
This warranty is in lieu of all other warranties, expressed or implied, and is the sole remedy with respect to product defects. No dealer,
distributor, installer or other person is authorized to modify or extend this Limited Warranty or impose any obligation on Peerless in
connection with the sale of any Peerless
®
product.
This warranty gives specic legal rights, and you may also have other rights which vary from state to state.
LIMITED FIVE-YEAR WARRANTY
Peerless-AV Europe
Unit 3 Watford Interchange,
Colonial Way, Watford, Herts,
WD24 4WP, United Kingdom
Customer Care
44 (0) 1923 200 100
www.peerless-av.com
© 2015, Peerless Industries, Inc.
Peerless-AV de Mexico
Ave de las Industrias 413
Parque Industrial Escobedo
Escobedo N.L Mexico 66050
Servicio al Cliente
01-800-849-65-77
www.peerless-av.com
© 2015, Peerless Industries, Inc.
Peerless-AV
2300 White Oak Circle
Aurora, IL 60502
Email: [email protected]
Ph: (800) 865-2112
Fax: (800) 359-6500
www.peerless-av.com
© 2015, Peerless Industries, Inc.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

NEC NP-PA703UL Installation guide

NP-PA703UL
NEC
Brand
NEC
Model
NP-PA703UL
Category
Projector mounts
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents