2. Herman Miller
  3. Teneo Storage Furniture
Teneo Storage Furniture

Herman Miller Teneo Storage Furniture Product Instructions

  • Hello! I've reviewed the Herman Miller Teneo side cladding installation instructions. This document details the process for installing both metal and veneer options, using clips for metal cladding and a peel-and-stick method for veneer. I'm ready to answer your questions about this process and the Teneo WA910 or WA911 cladding.
  • How many clips are needed for shorter metal clads?
    How many clips are needed for taller metal clads?
    What should you do after placing Tabs at bottom of Clad into holes in bottom of Ring?
1
Z
© 2010 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, and Teneo are among the registered trademarks of Herman MIller, Inc. Part no. 1b46cy rev C.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
YTeneo® Storage Furniture Side Cladding Installation
Cladding
A
BClip (4 or 5)
WA910 or WA911
1. Open Drawers or Doors to gain access for Clip installation.
Tabs
Ring B
A
2. Place Tabs at bottom of Clad (A) into holes in bottom of Ring. Let Clad rest against
Ring.
3. Secure Flange on Clad to Outside Rib on Ring with 4 Clips (B) for shorter Clads and
Outside
Flange
Rib
Holes
A
B
5 Clips for taller Clads. See opposite page for tall Clad Clip locations.
B
B
Parts Included:
Metal Side Cladding:
2
Z
© 2010 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, and Teneo are among the registered trademarks of Herman MIller, Inc. Part no. 1b46cy rev C.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
A
B
B
B
3
Z
© 2010 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, and Teneo are among the registered trademarks of Herman MIller, Inc. Part no. 1b46cy rev C.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Cladding
A
WA910 or WA911
A
1. Peel off dual Lock Backer.
2. Position narrow end on the Ring Bottom Ledge.
3. Swing close upper edge until it contacts Ring.
4. Firmly press Veneer Clad perimeter against Ring.
Lock Backer
Parts Included:
Veneer Side Cladding:
4
Z
© 2010 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, and Teneo are among the registered trademarks of Herman MIller, Inc. Part no. 1b46cy rev C.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
A
/