2. Herman Miller
  3. My Studio Environments

Herman Miller My Studio Environments Product Instructions

  • Hello! I've reviewed the instructions for the Herman Miller Bookshelf 1b27d0. This document provides guidelines on assembling the bookshelf, focusing on steps like removing the leg cap, inserting the post support, engaging the leg support and adjusting the glides. I am ready to help with any specific questions about this product.
  • What is the first step in assembling the bookshelf?
    What needs to be done after inserting the post support?
    What is the recommended height adjustment?
Z
© 2012 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Action Office and Resolve are among the registered trademarks of Herman Miller, Inc.
TM Sense, Setu, Tu, Traverse and Sayl are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b27d0 rev C.
1
YMy Studio Environments™ Bookshelf Installation
1
1. Remove Cap from leg of Bookshelf.
Store in safe place for future use.
IMPORTANT: Save these instructions for layout changes.
Bookshelf
Cap
Leg
Z
© 2012 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Action Office and Resolve are among the registered trademarks of Herman Miller, Inc.
TM Sense, Setu, Tu, Traverse and Sayl are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b27d0 rev C.
2
2
1. Insert Post Support into Leg.
Make sure spring pins in Post
Support engage into holes in Leg.
1. Slide Bookshelf into position with Leg Support
inserted into Post Support.
Make sure spring pins engage.
2. Adjust glides to level.
3. Height should be adjusted so there is
approximately 9 1/2” between top of Bookshelf
and bottom of Ledge.
Post Support
Leg 3
Leg Support
Ledge
9 1/2”
Glides
Post Support
/