2. BLOTZ
  3. B15-ME-204

BLOTZ B15-ME-204 Assembly Instructions

  • I have reviewed the instructions for the BLOTZ 15mm Ancient City Walls Short Wall - Gate model. This document provides a detailed step-by-step guide to assist you in assembling the model, from removing the pieces from the sprue to attaching the final components. It outlines the materials needed, such as PVA glue, sandpaper, and a sharp modeling knife. I'm ready to answer your questions about the assembly process.
  • What glue is required for assembly?
    What tool is needed to remove pieces from the sprue?
    What can be used to hold pieces while the glue dries?
    What can be used to clean the joints?
15mm Ancient City Walls – Short Wall - Gate
B15-ME-204
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue the connectors to the main support.
Take the second support and rear wall.
Glue them together as shown.
Take the inner arch pieces.
Glue them together.
Attach this to the model.
The base and gates.
Attach the model to the base, having slotted the
gates into their holes first.
Add the walkway.
The front wall pieces.
Add the front lower wall and crenellated piece.
Take these pieces from the sprue.
Glue the two connect pieces into place.
Then add the blanking pieces.
Finally add the long strip.
The finished model.
/