2. BLOTZ
  3. B20_ME_207

BLOTZ B20_ME_207, B20-ME-207, B28-ME-207, B28-ME-214 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ City Wall models B20-ME-207 and B28-ME-207. This document includes assembly instructions for creating a 20mm or 28mm scale long wall and gate using laser-cut wooden components. I'm ready to answer any questions you have about the construction process or the features of the model.
  • What type of glue is required for assembly?
    What is the purpose of sandpaper?
    Are there two scales of the model.
    What additional tools are needed?
20mm / 28mm Ancient City Walls – Long Wall - Gate
B20-ME-207 / B28-ME-207
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The images here show the 20mm version of this kit, but the 28mm version is constructed in exactly the same way.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports – the
wide connectors being the ones closest together.
Take the base, rear wall and supports.
Glue them together as shown.
Attach the base.
The central gate pieces.
Glue the sides and top together as shown.
Attach these to the base (as shown above) after
slotting the gates into place.
Add the walkway.
Glue the lower front walls to the model.
Add the crenellation section.
Finally add the long strip.
/