Troy-Bilt Storm 2410 Operating instructions

Storm 2410
Troy-Bilt
Brand
Troy-Bilt
Model
Storm 2410
Type
Operating instructions

This manual is also suitable for

Shift Lever
Chute
Directional
Control
Upper Handle
778-11820C© 2016 31BS6BN2
Chute Assembly
Chute Adapter
Chute Bracket
A. Place
shift lever
into F6
position.
B. Pivot
upper
handle
into
operating
position.
A
B
Place chute assembly
onto chute adapter.
Close the three
flange keepers.
Keepers will click
into place when
properly secured.
Loosen the top two lock nuts (a)
securing the upper and lower handle
and remove the two carriage screws (b)
from the lower handle and set aside .
Attach the two carriage screws (b) and
lock nuts (a) removed in Step 1. Finish
securing the handle by tightening the
top two lock nuts (c) loosened in Step 1.
Remove flat washer
and hairpin clip.
Insert chute
directional control
into chute bracket.
Secure with washer
and clip.
(a)
(a)
(b)
(b)
(c)
(c)
(b)
(b)
(a)
(a)
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Throttle
Control
Electric Starter
Outlet
Electric Starter
Button
Oil Fill /
Dipstick
Primer
Key
Choke
Control
Gas Fill
778-11820C© 2016 31BS6BN2
Move throttle control into
the Fast position.
Move the choke control
into the Choke
position.
A. Connect an
extension cord
to the electric
starter outlet.
B. Plug the other
end of the cord
into a three-
prong 120-volt,
grounded, AC
receptacle.
Push primer
three times.
Insert the key
into the key
switch until
the key snaps
into place.
Do not turn
the key!
A. To start engine,
push the starter
button.
B. When engine
starts, slowly move
choke control
into the Run
position.
C. Disconnect cord
from power
receptacle first and
then from snow
thrower’s outlet.
Fill fuel tank with clean,
fresh gasoline. Do not fill
above the base of fuel
tank neck.
Check the oil level using
the dipstick. Add oil if
necessary. (Refer to the
Operator’s Manual)
7
10
8
11
9
12
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
  • Page 1 1
  • Page 2 2

Troy-Bilt Storm 2410 Operating instructions

Storm 2410
Troy-Bilt
Brand
Troy-Bilt
Model
Storm 2410
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents