2. Troy-Bilt
  3. 31AS62N2711
31AS62N2711

Troy-Bilt 31AS62N2711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 31AS62N2711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How should I attach the chute assembly?
    Where can I find the key switch?
    How do I properly prepare the snow thrower for operation?
    How can I check the oil level in the snow thrower?
    What is the correct fuel to use in this snow thrower?
    How do I connect the power cord for the electric starter?
    What is the proper procedure for starting the engine?
    How do I change the choke control position after starting the engine?
    To stop the engine, what steps should I take?
    How to I disconnect the power cord?
778-11820A© 2010 31AS62N2
Chute Assembly
Handle Knobs
Chute Adapter
Upper Handle
Chute Control
Rod
Chute Bracket
Shift Lever
Place shift lever into F6 A.
position.
Pivot upper handle into B.
operating position
Tighten handle knobs.C.
A
B
C
Place chute assembly
onto chute adapter.
Close the three
flange keepers.
Keepers will click
into place when
properly secured.
Remove flat washer and
hairpin clip.
Insert chute control rod
into chute bracket.
Secure with washer and
clip.
1
3
2
4
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Oil Fill /
Dipstick
Electric Starter
Button
Electric Starter
Outlet
Primer
Key
Throttle
Control
Choke
Control
Gas Fill
778-11820A© 2010 31AS62N2
Move throttle control into
the Fast
position.
Move the choke control
into the Choke
position.
Connect power cord to A.
electric starter outlet.
Plug other end of power B.
cord into a three-prong
120-volt, grounded, AC
receptacle.
Push primer
three times.
Fill fuel tank with clean,
fresh gasoline. Do not fill
above the base of fuel
tank neck.
Check the oil level using
the dipstick. Add oil if
necessary. (Refer to the
Operator’s Manual)
Insert the key into the
key switch until the key
snaps into place.
Do
not turn the key!
To start engine, A.
push the starter
button.
When engine B.
starts, slowly move
choke control
into the Run
position.
Disconnect cord C.
from power
receptacle first and
then from snow
thrower’s outlet.
5
8
6
9
7
10
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
/