2. Troy-Bilt
  3. 31BM63P3711
31BM63P3711

Troy-Bilt 31BM63P3711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 31BM63P3711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How to adjust the chute?
    How to start the engine?
Hex Rod
Form No. 778-11821© 2009 31AM63P3
Chute
Handle Knobs
Chute Base
Upper Handle
Chute Support
Bracket
Chute Control
Head
Place shift lever into A.
F6 position.
Pivot upper handle B.
into operating
position
Tighten handle C.
knobs.
A
A
B
C
Place chute onto
chute base and
secure with the
hardware removed
in Step 2.
Remove cotter pin, wing nut A.
and hex screw from chute
control head.
Remove clevis B.
pin and bow-
tie pin from
chute support
bracket.
B
Squeeze the trigger on
the joystick and rotate
the chute by hand to
face forward.
The holes
in the rear of the
chute control head
will be facing up.
Insert the round end of
the hex rod (hole pointing
upward) as far as possible
into the chute control head.
Rotate the chute
control until the
silver arrow on
the pinion gear
faces upward.
Insert the hex end of the
rod (hole pointing upward)
into the pinion gear.
Secure the round end
of the hex rod to the
chute control head as
shown, with the cotter pin
removed in Step 2.
Shift Lever
Chute Control
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Oil Fill /
Dipstick
Electric Starter
Button
Electric Starter
Outlet
Primer
Key
Throttle
Control
Choke
Control
Gas Fill
Form No. 778-11821© 2009 31AM63P3
Move throttle control
into the Fast
position.
Move the choke control
into the Choke
position.
Connect power cord to A.
electric starter outlet.
Plug other end of power B.
cord into a three-prong
120-volt, grounded, AC
receptacle.
Push primer
three times.
Fill fuel tank with
clean, fresh gasoline.
Do not fill above the
base of fuel tank neck.
Check the oil level
using the dipstick.
Add oil if necessary.
(Refer to the
Operator’s Manual)
Insert the key into the
key switch until the
key snaps into place.
Do not turn the key!
To start engine, A.
push the starter
button.
When engine B.
starts, slowly move
choke knob into
the Run position.
Disconnect cord C.
from power
receptacle f irst and
then from snow
thrower’s outlet.
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
/