2. Ghent
  3. STG1M5436SILWH

Ghent STG1M5436SILWH Installation guide

  • Hello! I've reviewed the installation instructions for the ghent Sroll T-Base Glass Partition and its connector accessories, including models STGXXXX and STG-CONN-XXX. The document outlines the steps for unpacking, assembling, and safely docking the partition. It also mentions optional partition wall creation and attachment of Tri and Quad connectors. I'm ready to answer any questions you may have about the product based on this information.
  • What should I do after unpacking the Stroll T-Base unit?
    How should the Stroll T-Base unit be used?
    What can I do with two Ground Connectors?
(2)
Top Cap
(0 - 2)
Divider Rail
(1)
Stroll T-Base
Partition
(2)
#10-32 Pan
Head Screw
(Optional 1)
Quad Connector
(Optional 6-8)
#10-32 Flat
Head Screw
(1)
1/8" Hex
Wrench
(2)
Angle Connector
(Optional 1)
Tri Connector
(1)
Connector
Ground Connector
Non-slip tape
T-Base fully seated
in Connector
Pan Head Screw
Sroll T-Base Glass Partition / STGXXXX
Product Installation Instructions
www.ghent.com/install - Lebanon, Ohio 800-543-0550 IS-STG 3/21
Step 1:
Remove and unpack the Stroll T-Base unit,
Ground Connector, and Hardware.
Step 3:
Carefully roll the Stroll T-Base unit onto the Connector as shown. Please note for safe use
the Stroll T-Base unit should always be docked in the Connector when in use.
Step 4:
(Optional) Create a partition wall
by attaching two Ground Connectors
together with the Pan Head Screws.
Step 2:
After selecting a location for the Stroll T-Base partition place the Connector onto the ground in
front of the single wheel side. Align the Connector as shown.
Stroll T-Base
Partition
(1)
Quad Connector
Accessory
(6-8)
#10-32 Flat
Head Screw
(1)
1/8" Hex
Wrench
(1)
Tri Connector
Accessory
Connector
T-Base fully seated in
assembled Connector
Flat Head Screw
Connector
Tri Connector Accessory
Flat Head Screw
Connector
Quad Connector Accessory
Sroll T-Base Glass Partition / STG-CONN-XXX
Accessory Installation Instructions
www.ghent.com/install - Lebanon, Ohio 800-543-0550
IS-STG-CONN 3/21
Step 1:
Remove and unpack the Stroll T-Base unit,
Ground Connector, and Hardware.
Step 3:
Place the assembled Connector onto the ground. Then carefully dock the Stroll T-Base unit onto
the assembled Tri or Quad Connector as shown. Please note for safe use the Stroll T-Base unit should
always be docked in the Connector when in use.
Step 2:
Using two Flat Head Screws install one Connector onto the Connector Accessory as shown.
Repeat this step until all Connectors are attached.
/