Athens Stonecasting 04-914213TR Operating instructions

Assembling Your 2 Tier Acorn Leaf Fountain

Caution: Keep children and others from climbing, sitting, or leaning on the fountain

and its components. Failure to do so could cause serious injury.

Fountains have no interlocking component parts.

Fountain parts are held by gravity only.

ASSEMBLY INSTRUCTIONS:

1. Place Pedestal (A) on level, rm foundation.

Use a level and shims to assure bowl is level.

2. Balance bottom bowl (B) on pedestal (A)

3. Place pump into pump cavity of bowl (B). Guide electrical plug thru hole

in bottom of bowl and drop cord thru pedestal (A).

4. Center bowl (B) over pedestal (A)

5. Wrap cord plug around cord and wedge tightly in hole in bottom of bowl(B).

6. Fill around plug with silicon, fountain putty, or plumbers putty and allow to set

up.

7. Attach hose to center of pump. ** Be sure not to let hose kink.

8. Level with plastic shims.

9. Position center pedestal/riser (C) over pump cavity.

10. Guide hose thru top bowl (D) and position in center of pedestal/rise (C).

11. Level top bowl (D) with plastic shims. Cut off excess hose. Leave 2 - 3 inches

for topper (E).

12. Sit topper (E) on top bowl (D) and slide hose into bottom of topper (E).

13. Fill fountain with water. Plug pump cord into 110 volt GFI outlet.

14. Pump has a ow control slide switch with can be adjusted to modify

water ow to reach desired volume.

MATERIALS LIST:

-Pump

-Hose

-4' Level

-Plastic Shims or Metal Washers

- Silicone or Fountain Putty

Contact:

Download PDF