Athens Stonecasting 04-010013MO Operating instructions

Assembling Your Patio Fountain

Caution: Keep children and others from climbing, sitting, or leaning on the fountain

and its components. Failure to do so could cause serious injury.

Fountains have no interlocking component parts.

Fountain parts are held by gravity only.

ASSEMBLY INSTRUCTIONS:

1. Place Pedestal (A) on level, rm foundation.

2. Balance bottom bowl (B) on pedestal (A) Use a level and shims to

assure bowl is level.

3. Place pump into pump cavity of bowl (B). Position electrical cord in

slot outside pump cavity.

4. Center bowl (B) over pedestal (A)

5. Align boy topper (C) over pump cavity. Push hose from pump through

hole in middle of topper. The hose needs only to go in a few inches.

6. Fill fountain with water. Plug pump cord into 110 volt GFI outlet.

7. Pump has a ow control slide switch which can be adjusted to modify

water ow to reach desired volume.

MATERIALS LIST:

-Pump

-Hose

-4' Level

-Plastic Shims or Metal Washers

Contact:

Download PDF