Thank you for buying an Angelo Décor Fountain!
We hope you will find these instructions helpful in setting up your fountain.
If you have any issues with this item, please DO NOT return the unit to place of purchase.
Please visit our web site, www.angelodecor.com, for assistance and warranty information.
First unpack carton carefully, arranging parts safely in your working area.
Pass the pump cord down
the cord pipe.
Tubing go through the riser. And
twist and lock riser to the bowl.
The pump is preset to full
strength. If splash is a
concern, adjust as needed.
Connect the tubing
to pump.
Pass the pump cord through the pedestal.
Align the cord with the groove at the base.
Twist and lock
bowl to pedestal.
Now simply fill with clean water and plu
into a
rounded GFCI outlet
We recommend keepin
bowl 3/4 full of water to avoid pump burnout.
Product must be properly stored for winter.
Pass the pump cord down
the cord pipe.
Tubing go through the riser. And
twist and lock riser to the bowl.
The pump is preset to full
strength. If splash is a
concern, adjust as needed.
Connect the tubing
to pump.
Insert the supplied PVC
pipe to the middle bowl as
shown.
Tubing go through the small bowl
and set the bowl to the riser.
Pass the pump cord through the pedestal.
Align the cord with the groove at the base.
Twist and lock
bowl to pedestal.
The final assembly
should look like this
Slide the top feature
into the place.
Install the pump
access door.