Athens Stonecasting 04-501213GR Operating instructions

Assembling Your Old World Fountain

Caution: Keep children and others from climbing, sitting, or leaning on the fountain

and its components. Failure to do so could cause serious injury.

Fountains have no interlocking component parts.

Fountain parts are held by gravity only.

ASSEMBLY INSTRUCTIONS:

1. Place bowl (A) on level, rm foundation.

Use a level and shims to assure bowl is level.

2. Place pump into pump cavity in bowl (A) and attach hose. Drop Electrical cord

over side of bowl (A) in cord slot.

3. Align top set on base bowl (B). Push hose from pump

through hole in middle of tallest bowl (C), level and shim

if needed. Fill around hose tubing with putty to keep water from running

back down hole.

4. Cut of excess hose.

5. Fill fountain with water, plug into 110 volt GFI outlet.

6. Pump has a ow control slide switch which can be adjusted to modify water

ow to reach desired volume.

MATERIALS LIST:

-Pump

-Hose

-4' Level

-Plastic Shims or Metal Washers

- Silicone or Fountain Putty

Contact:

Download PDF