35
USE OF THE SELECTION CONTROLS
A
. PROGRAMME SELECTOR KNOB
This control allows you to select the washing programmes.
Tu rn the selector so that the number or symbol of the desired
programme is opposite the reference indicator (p).
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button
(H) before selecting the programme
.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the On/Off button. Press again to recommence once the
modification has been completed.
B
. TEMPERATURE SELECTOR KNOB
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
This control allows you to select the temperature of your
wash.
If you wish to carry out a cold wash, turn the knob until the
cold symbol coincides with the selector mark.
Do not exceed the maximum temperature recommended
for each cycle in the table of programmes.
D.
SPIN VARIATION BUTTON 800/400
When this button is pressed, the spin after the last rinse will be
at 400 r.p.m. instead of 800 r.p.m.
N.B.: The spin in programmes for mixed, synthetic and delicate
fabrics is always at 400 r.p.m.