2. Razor
  3. Power A5

Razor Power A5 User manual

  • Hello! I've reviewed the user manual for the Razor Power A5 W13113202023 electric scooter, specifically focusing on front fork and headset bearing replacement procedures. The document provides a detailed step-by-step guide, including safety instructions and necessary tools. I'm ready to assist you with any questions you might have about this maintenance process.
  • What should I do before starting maintenance?
    What tools are needed for this procedure?
    What is the first step in the procedure?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Small Flat screwdriver
C. Long needle nose pliers
D. 3 mm Allen wrench
E. 5 mm Allen wrench
F. 36 mm wrench or a large adjustable wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove the screw located at
the very front of the deck. Pull the deck cover off from the
deck.
Disconnect the throttle cable from the controller.
POWER A5
FRONT FORK - HEADSET BEARINGS
REPLACEMENT PROCEDURES
PART # W13113202023
HEADSET BEARINGS PART #W13111813026
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Using a small flat screwdriver, remove the grommet
inside the opening of the deck.
Using a smal flat screwdriver, remove the C ring from the
folding mechanism pin. Slide the pin out from the frame.
Unfold the unit. Using a pair of long needle nose pliers,
remove the spring from the folding mechanism pin.
Using a 3 mm Allen wrench, remove the set screw at the
back of the folding knob while holding the knob.
Step 5 Step 6
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
3
Step 7 Step 8
Unscrew and remove the knob. Slide down the plastic
block of the folding mechanism.
Using a 5 mm Allen wrench, loosen the bolt from the
collar clamp and remove the stem from the fork.
Set aside all the parts from the folding mechanism.
Using a 36 mm wrench or a large adjustable wrench,
loosen the lock nut from the headset bearings.
Step 9 Step 10
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
4
Step 13
Reverse the steps.
ATTENTION: Charge battery 10 hours before using.
Using a 3 mm Allen wrench, loosen and remove the two
(2) screws from the fork limiter cover.
Using a 5 mm Allen wrench, loosen and remove the
limiter screw and slide the fork down.
Step 11 Step 12
/