2. Razor
  3. W13113202032
W13113202032

Razor W13113202032 Operating instructions

  • Hello! I've reviewed the user manual for the Razor POWER A2 W13113202032, which details the replacement procedure for the Quick Release and Stem. This manual includes step-by-step instructions with safety warnings to guide you through the process. I am ready to answer your questions about this device and its maintenance.
  • What tools are required for the replacement procedure?
    What is the first step in the replacement process?
    What should be done before starting any maintenance?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Small Flat screwdriver
C. Long needle nose pliers
D. 3 mm Allen wrench
E. 5 mm Allen wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove the screw located at
the very front of the deck and pull the deck cover off from
the deck.
Disconnect the throttle cable from the controller.
POWER A2
QUICK RELEASE / STEM
REPLACEMENT PROCEDURES
PART # W13113202032
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Using a small flat screwdriver, remove the grommet
inside the opening of the deck.
Using a smal flat screwdriver, remove the C ring from the
folding mechanism pin. Slide the pin out from the frame.
Unfold the unit. Using a pair of long needle nose pliers,
remove the spring from the folding mechanism pin.
Using a 3 mm Allen wrench, remove the set screw at the
back of the folding knob while holding the knob.
Step 5 Step 6
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
3
Step 7 Step 8
Unscrew and remove the knob. Slide down the plastic
block of the folding mechanism.
Using a 5 mm Allen wrench, loosen the bolt from the
collar clamp and remove the stem from the fork.
Set aside all the parts from the folding mechanism.
Open the quick release.
Step 9 Step 10
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
4
Step 13
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
Using a 3 mm Allen wrench, loosen the screw from the
quick release.
Slide the quick release up from the stem and replace it.
Step 11 Step 12
/