Razor W15128785048 User manual

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

WARNING

Step 1 Step 2

Required Tools: (Not included)

A. Phillips screwdriver

B. 21 mm wrench or adjustable wrench

C. Two 8 mm wrenches

D. Long needle pliers

E. 10 mm wrench

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Using a Phillips screwdriver, remove seven (7) screws

from the side of the battery cover with the power switch.

Remove four (4) screws, two at the front and two at the

back of the battery cover. Pull the cover out. Be careful not

to damage the wires.

RAMBLER 16 REAR WHEEL-MOTOR

REPLACEMENT INSTRUCTIONS

PART # W15128785048

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

Step 3 Step 4

Locate and disconnect the four (4) motor connectors from

the controller.

Using two (2) 8 mm wrenches, loosen and remove the

bolt and lock nut that holds the cable guide bracket.

Removeit.

Using a 21 mm wrench or adjustable wrench, loosen the

lock nuts from both sides of the axle. Push the wheel down

and out from the unit.

Using long needle pliers, remove the end cap from the

brake cable and save for re-installation. Using a 10 mm

wrench, loosen the lock nut that holds the brake cable in

place. Pull the cable out from the unit.

Step 5 Step 6

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

Step 7

Reverse the steps.

ATTENTION: Charge battery 12 hours before using.