5019 100 75050
AKR 500
AKG 751 - AKG 753
1.
Control panel.
2.
Grease filters (inside the extractor grille).
3.
Lighting unit.
4.
Pull-out steam deflector.
5.
Steam deflector pivot (inside the extractor.
hood, at the two ends of the steam deflector).
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER-
Fig. 1
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extractor grille (
b, c
).
4.
Remove the device fixing the grease filter (
d
).
5.
Remove the dirty grease filter.
6.
After replacing or cleaning the grease filter
(depends on model), remount in reverse
order, making sure the entire extraction
surface is covered.
REPLACING BULBS -
Fig. 1
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extractor grille (
b, c
).
4.
Remove the burnt-out bulb. Only 40W max
E14 bulbs should be used.
5.
Remount the extractor grille.
MOUNTING OR RENEWING THE
CARBON FILTER -
Fig. 2 - 3
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extraction grille (
b, c
).
4. Fitting:
position the carbon filter over the
motor protection grille within the reference
marks (
f
) - the reference mark (
g
) on the edge
of the carbon filter should line up with the
arrow on the fan shroud (
h
), and turn
clockwise.
Removing:
turn anti-clockwise.
5.
Remount the extractor grille.
CONTROL PANEL
A.
Selected speed display.
B.
Speed selector.
C.
Light switch.
Fig. 1
1
3
a
b
d
b
4
c
5
2
small amount of steam and fumes
large amount of steam and fumes
medium amount of steam and fumes
O 1 2 3
OI
Fig. 2
C
A
B
AKR 500
AKG 753
AKG 751
h
f
g
Fig. 3
PRODUCT DESCRIPTION
F NL E PGBD GRI