Amerec Speaker Operating instructions

Brand
Amerec
Model
Speaker
Type
Operating instructions

Amerec Speaker is a full-range, coaxial waterproof speaker with a maximum wattage of 80W. It has a 4Ω impedance and weighs 16.6 oz (470g). The speaker is designed to be mounted in a wall or ceiling, and comes with four stainless steel wood screws for mounting. It also has two mounting latches on the back side of the speaker for easy removal of the speaker grill. The speaker is designed to be weatherproof and can be used in both indoor and outdoor applications. It is perfect for use in bathrooms, kitchens, patios, and other areas where moisture is present.

Amerec Speaker is a full-range, coaxial waterproof speaker with a maximum wattage of 80W. It has a 4Ω impedance and weighs 16.6 oz (470g). The speaker is designed to be mounted in a wall or ceiling, and comes with four stainless steel wood screws for mounting. It also has two mounting latches on the back side of the speaker for easy removal of the speaker grill. The speaker is designed to be weatherproof and can be used in both indoor and outdoor applications. It is perfect for use in bathrooms, kitchens, patios, and other areas where moisture is present.

4211-197 11/20/20
Waterproof Speakers
Installation Instructions
Ratings
Type: Full-range, coaxial waterproof speaer
Impedance: 4 Ω
Watts (single speaker): 80W max
Weight (single speaker): 16.6 oz (470g)
INSTALLATION
1. Cut a 5-1/4” [133 mm] diameter mounting hole using the attached template and drill holes for the 4 mounting
screws.
• Four stainless steel wood screws are inculded for mounting your speaker.
• Depending on the wall or ceiling material used, you may need to use molly bolts instead. If so, use #6
molly bolts and be sure that the bolts are stainless steel or brass to prevent corrosion later.
2. Remove the speaker grill by using a small screwdriver to pry up in the 4 recesses on the front grill or by
gently prying the two latches on the back side of the speaker (see below).
Pry Point, 4 places
Latch,
2 places
4211-197 11/20/20
Waterproof Speakers
Installation Instructions
Refer to the fi gures at right for steps 3 to 6.
3. Connect the wires from the amplifi er to the speaker. The speaker
wires should already be run to the speaker mounting location and
the wire ends pulled out through the mounting hole. Connect
the + terminal on the amp to the + terminal on the speaker and the
- terminal on the amp to the - terminal on the speaker. When
installing two speakers, make sure the + and - wiring matches
on both speakers for the best sound.
4. Apply silicone to the backside of the speaker on the fl at mounting
surface and the fl at surfaces around the screw holes. When the
speaker is mounted in a wet location, it must be sealed against
the mounting surface in order to prevent moisture damage.
5. Mount the speaker by setting it into its mounting hole. Hold it
in place (painter’s tape may work well to hold the speaker in
place) while installing the mounting screws. If using moly bolts,
make sure the molys are in place before mounting the speaker.
Tighten the screw fi rmly and clean any excess silicone, then let
the silicone dry.
6. Test the speaker and if it is working well, carefully snap the
speaker grill in place.
For additional assistance contact
P.O. Box 2258 Woodinville, WA 98072
800-363-0251
Fax: 425-951-1130
email: [email protected]
Silicone
Speaker Wires
4211-197 11/20/20
Waterproof Speakers
Installation Instructions
CUT LINE
SCREW HOLE
4 PLACES
5 1/4” [133 mm] DIAMETER
OUTSIDE
EDGE OF
SPEAKER
  • Page 1 1
  • Page 2 2
  • Page 3 3

Amerec Speaker Operating instructions

Brand
Amerec
Model
Speaker
Type
Operating instructions

Amerec Speaker is a full-range, coaxial waterproof speaker with a maximum wattage of 80W. It has a 4Ω impedance and weighs 16.6 oz (470g). The speaker is designed to be mounted in a wall or ceiling, and comes with four stainless steel wood screws for mounting. It also has two mounting latches on the back side of the speaker for easy removal of the speaker grill. The speaker is designed to be weatherproof and can be used in both indoor and outdoor applications. It is perfect for use in bathrooms, kitchens, patios, and other areas where moisture is present.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents