Amerec 6x9 Waterproof Speaker Installation guide

Brand
Amerec
Model
6x9 Waterproof Speaker
Type
Installation guide
4211-197 08-24-12
6 x 9 Waterproof Speakers
Installation Instructions
Ratings
Impendance: 4 Ω
Watts: 90W max
Min. Temperature: 32°F (0°C)
Installation
1. Cut a speaker mounting hole in the mounting surface using template (see pages 3 & 4).
2. Connect the speaker’s two SPK terminals to the sound source. Insure that the positive terminal
of the speaker (red +) is connected to the positive (+) terminal of the sound source. This is very
important: if the speakers are connected out of phase the sound quality will be affected.
3. If using the speaker’s LEDs - Connect the speaker’s two LED terminals: connect the positive
LED terminal (red +) to a +12VDC control line and the negative (-) LED terminal to ground.
Front Rear
Ground from iPod Dock/Harness
Triggered +12VDC from iPod Dock/Harness
Speaker (-) from iPod Harness
Speaker (+) from iPod Harness
LED Lights
4211-197 08-24-12
6 x 9 Waterproof Speakers
Installation Instructions
4. Remove the grill then the foam sheet from the speaker frame.
5. Swing the plastic tabs (clamps on back of the speaker) to their most counterclockwise position.
Note: If mounting the speaker in a wet location, make sure the mounting gasket is in place or
add a bead of silicone to seal the speaker to the mounting surface before installing the
speaker in its mounting cut-out.
6. Insert the speaker into the mounting cutout then tighten the four stainless steel screws located
in the front panel of the speaker. Tighten until the speaker is fi rmly secured in place.
Note: If the mounting surface is thicker than 3/4” (19mm), the plastic clamps may
be trimmed back to accommodate a wall thickness of up to one inch.
7. Carefully place the foam sheet on the front of the speaker and remount the grill.
For additional assistance contact Amerec Technical Support at 1-800-363-0251.
P.O. Box 2258 Woodinville, WA 98072
800-363-0251 Fax: 425-951-1130
email: address: [email protected]
FrontRear
Mounting Tab Screws
Mounting Tab
4211-197 08-24-12
6 x 9 Waterproof Speakers
Installation Instructions
CUT
CUT
CUT
CUT
Drill 5/8” (16mm) Diameter
4.96” (126mm) Center-to-Center
7.60” (193mm) Center-to-Center
8.23” (209mm) Edge-to-Edge
5.60” (142mm) Edge-to-Edge
4211-197 08-24-12
6 x 9 Waterproof Speakers
Installation Instructions
CUT
CUT
CUT
CUT
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Amerec 6x9 Waterproof Speaker Installation guide

Brand
Amerec
Model
6x9 Waterproof Speaker
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents