American Dynamics AD1305 Installation guide

Contents - 1 Elevator Camera Housing and 1 Allen Wrench

Description

The 1305 Elevator Camera Housing is composed of a 2-piece housing. The rear piece is held to the front with two allen screws.

Locating and Mounting of Camera Housing

1. Select an appropriate location. Make sure no obstructions or obstacles exist around the selected site.

2. Measure the mounting area for the camera housing.

3. Securely attach the camera within the rear housing piece.

3. Securely attach the rear housing piece to the selected area.

4. Attach the front housing piece to the rear piece and secure the two pieces together with the two supplied allen screws.

Note: These installation instructions are intended only as a recommendation to qualified personnel installing this housing. Use these

installation instructions as a guideline. These instructions are not to be construed as the only means of installation that can be

used. It is recommended that the purchaser of this be cognizant of local regulations regarding safety, electrical, or structural

requirements.

AD1305

Elevator Camera Housing

Installation Instructions

IF YOU ENCOUNTER ANY PROBLEMS

OPERATING THIS UNIT, OR NEED ASSISTANCE,

CALL OUR TECHNICAL SUPPORT CENTER

within the United States 1-800-442-2225

outside the United States (914) 365-5812

AMERICAN DYNAMICS

10 Corporate Drive

Orangeburg, New York 10962

Business (914) 365-1000

Technical Support: (800) 442-2225

FAX: 914-365-1007

OP1305A

February 1994

Printed in USA

Information furnished by AMERICAN DYNAMICS is believed to be accurate and reliable. However, no responsibility is assumed by AMERICAN

DYNAMICS for its use; nor for any infringements of other rights of third parties which may result from its user. No license is granted by

implications or otherwise under any patent or patent rights of AMERICAN DYNAMICS.

Download PDF