-’4
READAND UNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE
INSTRUCTION SHEET NO.
Thisfixtureisintendedfor installation in accordance with the National Electrical Code and local regulations,
To assure full compliance with local codes and regulations, check with your local electrical in$pactor before
installation. To pravent electrical shock, turn off electriciV at fuse box before proceeding.
IS:2000P1
Retainthese instructionsfor maintenance@reference.
R0894
Page 1 of 1
INSTALLATION PROCEDURE FOR FRAME-IN KIT 2000PI
,040
5
UNTING FRAME
GA,STEEL
(8]#12AWGBRANCHCIRCUIT
CONDUCTORSSUITABLE FORAT LEAST
90° PERMITTEo IN
JUNCTION BOX
WARNING-(RISKOFFIRE)DONDT INSTALLINSULATION WITHIN 3 INCHES OFFIXTURESIDES ORWIRING
COMPARTMENT, NORABDVEFIXTUREIN SUCHA MANNER TD ENTRAPHEAT.
1.
FRAME-IN AND WIRE-IN
Fasten MOUNTING FRAME to wood joist, Lina up bottom edge of
INGBAR
ADJUSTABLEMOUNTINGBARwith bottom of wood joist (Fig. 1).
Wira to supply Iaads. (For cabla, usa built-in cable clamp in J-BOX,)
Whita fixture lead to nautral supply Iaad. Black fisture lead to hot
(120V.) supply Iaad. Bara fixture wire to supply ground. Usa wiranuts
(local hardwara itams), Placa all alactrical connations in tha J-BOX.
Attach J-BOX COVER onto J-BOX,
MOUN
M EDGE
NOTE ADJUSTABLE MOUNTING BARS can be axtended for 24
OFWOOD
mounting,
For suspanded ceiling, maka certain that tha bonom of
MOUNTING FRAME is no higher than 1” above ceiling line (Fig, 2).
FIG.
1
2. CLOSE-IN
Install in plasterboard or cihar dry
type ceiling, as required. Hole in
board can ba cut aither on the floor or after the board is nailed to the
tailing, using MOUNTING FRAME opaning as cutting guida, (Maka sure
ROTO-CLIPSara rotated out of hole araa to be cut,)
NOTE Forwetplastertailing,usaPlastarRingAccassoryND.1959(Ndar
IV]
saparstaly).
3. SNAP-IN
}
SEE SEPARATE REFLECTOR
AR
4. PUSH-UP
TRIM INSTRUCTION SHEET
M C> I+ TC>LI 1:1?”
SECAUCUS, NEW JERSEY 07096
MONTREAL, QUEBEC, CANAOA
