Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.030519
2 of 4
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
OEM Monitor
OEM GVIF
Cable
OEM Headunit
GVIF Video Cables
Front Camera Input
Rear Camera Input
To OSD Control Pad
Front/Rear Camera +12V Power
Ground
Green = Rear Camera Manual Trigger*
Blue = Front Camera Manual Trigger*
RVCGM-80M
MODULE
MAIN
*Use these wires if not using CAN Trigger.
Green wire = Connect to Reverse Light +12V
Blue wire = Connect to +12V using a toggle switch
VIDEO
LVDS Video
Extension Board
Red = +12V ACC
Black = Ground
Brown = CAN High
Video Extension Cable
RVCGM-80M
CAN WIRE CONNECTION:
Front & Rear Camera Integration Interface for
Select CHEVROLET and BUICK Vehicles with 7” MyLink Systems
The RVCGM-80M detects the CAN communicaons in the
vehicle. Tap the BROWN wire (GM LAN) on the power harness
to the GREEN wire (PIN# 28) on the 44 pin OEM connector
behind the headunit Reverse gear engagement is automacally
detected and will power on the rear camera. The front camera
will power on when the gear is put to Drive. The delay OFF of
the front camera can be set in the OSD menu. Time delay OFF
can be set from 1 to 60 seconds.
If for some reason the CAN connecon cannot detect the
reverse gear communicaon, connect the GREEN wire on the
RVCGM-80M power harness (Rear Camera Manual Trigger) to
the reverse light wire +12V.
The Front camera also be also be manually triggered by
connecng the BLUE wire (Front Camera Manual Trigger) to
+12V.
GREEN wire Single CAN wire PIN# 28