Crux SWRSU-38D User manual

Category
Car video systems
Type
User manual
Crux Interfacing Solutions • 21541 Nordhoff St Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.230201
SWRSU-38D
Radio Replacement with
Select Amplied 2017 - Up Subaru Vehicles
Steering Wheel Control Retention for
1 of 2
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
PRODUCT FEATURES:
PARTS INCLUDED:
SWRSU-38D Module SU-38D Harness Antenna Adapter SWC Cable
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
4-Pin
Connector
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
+12V Constant Yellow
+12V ACC Red
Ground Black
Illuminaon on (+) Orange
Antenna Turn on Blue
Reverse Trigger Purple/White
Right Front (+) Gray
Right Front (-) Gray/Black
Le Front (+) White
Le Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Le Rear (+) Green
Le Rear (-) Green/Black
TO FACTORY
HARNESS
12-Pin Black
Connector
Ground
AFTERMARKET
RADIO SELECTOR
(See Page 2)
SUBARU
SWC SETTING
(See Page 2)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Rear View Camera Signal Yellow RCA
(Retain OE Camera)
Audio Input Red/White RCA
(Retains Factory AUX Input)
28 PIN
10 PIN
6 PIN
5 PIN
ANTENNA ADAPTOR
(Included in Kit)
5 -Pin OEM
Camera
Connector*
*NOTE: If the factory radio does not
have a 5 pin camera connector, plug
these connectors together to retain
the factory backup camera.
Connector A
- Retains Harman Kardon amplifier
Crux Interfacing Solutions • 21541 Nordhoff St Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.230201
SWRSU-38D
Radio Replacement with
Select Amplied 2017 - Up Subaru Vehicles
Steering Wheel Control Retention for
2 of 2
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
DIP SWITCH SETTINGS:
SUBARU STEERING WHEEL CONTROL DIP SWI TCH SETTING:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND: DIP: 1 2 3 4
Atoto, Dual, Farenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony
OFF OFF ON ON
OFF OFF ON ON
OFF OFF ON ON
OFF OFF OFF OFF
OFF ON ON OFF
OFF ON ON ON
OFF ON OFF ON
OFF ON OFF OFF
OFF OFF ON OFF
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
NOTE:
check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
3.5MM SWC CABLE
VEHICLE APPLICATIONS:
SUBARU
2018 - 2022
2017 - 2022
2018 - 2022
2018 - 2022 Legacy w/ Harman Kardon Amplier
Outback w/ Harman Kardon Amplier
2018 - 2021 WRX / STi w/ Harman Kardon Amplier
Impreza w/ Harman Kardon Amplier
DIP: 5 6 7 8
#1
#2
ON OFF OFF ON
OFF ON OFF ON
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Subaru
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
Note that there are some radios that only have
NOTE: = Phone pick up and hang up buttons will be reversed.
STARLINK RETENTION:
NOTE:
2019 - 2022 Ascent w/ Harman Kardon Amplier
Crosstrek w/ Harman Kardon Amplier
DIP
switch
settings
for
Pioneer
receivers:
~/:·
c!
.
-~.:!:=~~==
~=
Location
of
the
switch
may
vary
on
the
Interface
(Comer
or
Middle).
Please
note
that
interfaces
with
DIP
at
the
end
of
the
LOT#
are
installed
with
the
switch.
Set
DIP
switch
to
"3V3"
position
for
support
of
NEW
generation
Pioneer
steering
wheel
button
control.
Set
DIP
switch
to
"5V"
position
for
support
of
OLD
generation
Pioneer
steering
wheel
button
control.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Crux SWRSU-38D User manual

Category
Car video systems
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI