Crux ACPGM-80N seamlessly integrates Android Auto and CarPlay into your compatible GM vehicle's infotainment system, allowing you to connect your smartphone and access your favorite apps, music, and navigation directly from your car's display. It also adds front and rear camera inputs, maintaining the functionality of your original backup camera and displaying the front camera automatically when shifting from reverse to drive.
Crux ACPGM-80N seamlessly integrates Android Auto and CarPlay into your compatible GM vehicle's infotainment system, allowing you to connect your smartphone and access your favorite apps, music, and navigation directly from your car's display. It also adds front and rear camera inputs, maintaining the functionality of your original backup camera and displaying the front camera automatically when shifting from reverse to drive.
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609211 of 9
- Smart-Play Integraon system allows connecon of Android and other phones to the GM infotainment system.
- Made for Android Auto and CarPlay.
- Adds front and rear aermarket camera inputs.
- Retains funconality of the OEM backup camera if present.
- Front camera automacally shows on the screen aer changing the gear from reverse to drive.
- Forced view funcon for front and aermarket rear camera.
PRODUCT FEATURES:
ACPGM-80N Module Power Harnesses Smartphone Interface Module
USB Extension Cable 4K HDMI Cable Microphone
LVDS Video Cable 3.5mm Aux Cable Smart-Play Module Power Harness
OSD Controller
PARTS INCLUDED:
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609212 of 9
WIRING DIAGRAM:
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
MAIN
ACPGM-80NC
Smart-Play / Android Auto Integration
for GM Vehicles with CUE & MyLink Systems
R
INTERFACING SOLUTIONS
V IDEO
REAR CAMERA
FRONT CAMERA
Front Camera
12V Power & Ground
Rear Camera
12V Power & Ground
OSD
CONTROL
PAD
OSD Control Pad is used to
adjust the settings. Must be
unplugged and stored after.
LVDS
Adapter
Cable
To the LVDS Connector
behind top side of radio
From the LVDS Connector
behind top side of radio
To the 10-pin connector
behind top side of radio
From the 10-pin connector
behind top side of radio
Fuse
***See Special Note on page 3 regarding LVDS connections on RE models***
Red
Red
Black
Black
Multi/IO
HDMI
Smart-Play Module
R
INTERFACING SOLUTIONS
HDMI
Power Port
+12V ACC (Red)
GND (Black)
Aux Cable
To factory
Aux Input
Microphone
Original Smartphone
Cable To Smartphone
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
DIP SWITCH SETTINGS:
DIP SETTING VEHICLE
1 to 8 ALL UP Malibu and Volt
1DOWN Corvee C7
2DOWN Escalade, CTS-V
3 UP No Funcon
4DOWN Cruze (with 8” screen)
5 DOWN Cadillac XT5
6DOWN Impala, Suburban, Tahoe, Yukon, Sierra, Acadia, Silverado, Yukon (with RSE)
7 DOWN Suburban (with RSE), Tahoe (with RSE)
1 & 5 DOWN Colorado
2 & 5 DOWN Escalade, CTS, CTS-V, SRX (with no OEM front camera)
RSE = Rear Seat Entertainment
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609213 of 9
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
Plug and play connecons behind the top side of the radio.
Suburban, Tahoe, Yukon models with Rear Seat
Entertainment Systems have 2 LVDS cables on
the back of the radio.
Suburban, Tahoe, Yukon with Rear Seat Entertainment (RSE) wiring connecons:
On RE models, the power harness is plugged in behind
the headunit but the LVDS cable is plugged in at the
HMI module (usually found behind the glove box).
Connecon is made on the blue LVDS connector on
the HMI module.
INSTALLATION INSTRUCTIONS:
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609214 of 9
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
SPECIAL NOTE:
On Impala and Suburban, Tahoe, Yukon models with Rear Seat Entertainment Systems, the LVDS cable
connecon on the ACPGM-80N LVDS adapter board is the opposite of the standard connecon. Please take
note of this when plugging in the LVDS connectors. See image below.
ACPGM-80N
LVDS OUT
OEM
Cable
Cadillac and Corvee C7 with 10 pin Connector at headunit
For Cadillac and Corvee C7 installaons, you must cut the ACPGM-80N 10 pin connectors and hardwire it to
the OEM connector wires.
ACPGM-80N POWER HARNESS
White LIN Bus
Blue/White MMI
Brown/White CAN
Red +12V Constant
Black Ground
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609215 of 9
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
Cadillac and Corvee C7 Connecon with 10 Pin connector:
Cadillac and Corvee C7 10-Pin
Connector at headunit
LIN (Blue wire)
MMI (White wire)
Cut Green wire Pin #8
ACPGM-80N
Harness
Cut the Green wire on pin #8 on the 10 pin
factory connector and connect the LIN (blue
wire) and MMI (white wire) of the ACPGM-80N
harness following the diagram above.
10 Pin connector
PIN 1 = B+ connect to VCC Red wire
PIN 3 = CAN connect to CAN High (White/Brown) wire
PIN 8 = LIN (see connecon diagram above)
PIN 10 = Ground connect to Black wire
30 Pin ACPGM-80N main module pin out.
(Note: Wire colors can be dierent but pin
locaons will remain the same.
LIN (Blue wire)
MMI (White wire)
Cut Green wire Pin #6
ACPGM-80N
Harness
16 Pin connector
Cadillac Connecon with 16 Pin connector:
PIN 6 = LIN (see connecon diagram above)
PIN 9 = B+ connect to VCC Red wire
PIN 12 = CAN connect to CAN High (White/Brown) wire
PIN 16 = Ground connect to Black wire
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609216 of 9
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
OSD Control Pad
The OSD Seng Screen automacally pops up when the OSD Control Pad is connected.
ON SCREEN DISPLAY (OSD) SETTINGS:
Use the OSD menu to make the necessary sengs. Remember to Run Save&Reboot aer the sengs
are made. Unplug the OSD Control Pad aer seng the cameras and keep it in a secure locaon in
case it is needed to change the sengs.
UP
DOWN
LEFT RIGHT
ENTER
Plug in 4K HDMI Cable Plug in 3.5mm Aux Cable
to factory Aux Input
Plug in original smartphone
cable to USB Ext. cable
GM vehicles without Rear Seat Entertainment (RSE) wiring connecons:
Plug and Play harness plugs
behind radio
ACPGM-80N LVDS video
cable plugs behind radio
LVDS Video Connecon
ACPGM-80N
LVDS OUT
OEM
Cable
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609217 of 9
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
REAR AND FRONT CAMERA SETTING
SMART-PLAY SETTING
Aer plugging in the OSD controller,
navigate down to LVDS Input and
set to ON. Push RIGHT buon to go
to the next menu.
Set Navi Brand to NV17 Navigate the OSD back
the main menu and go to
Save&Reboot then Run.
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609218 of 9
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
FRONT CAMERA SETTING
The front Camera will automacally show on the screen when the gear is put to Drive from Reverse. Set the delay
me on the OSD menu. Delay me can be set from 1 to 60 seconds aer a pung the car to drive from reverse.
Dynamic Parking Guide Lines
To turn ON the Dynamic Parking Guide Lines, go the Rear Input > Rear Set and turn ON Warning LANG.
Go back to the root menu and Run Save&Reboot. Remember to unplug the OSD Control Pad otherwise
the unit will not funcon properly. Set the parking brake on, start the car, put the gear in reverse, turn the
steering wheel all the way to the le and all the way to right then put it in the center. The ACPGM-80N
will calibrate automacally.
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0609219 of 9
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
ACPGM-80N
Smart-Play Integration with Multi Camera Inputs
for Select 2013-2018 GM Vehicles with CUE & MyLink Systems
FORCE VIEWING THE FRONT CAMERA:
Press for 2 seconds = Force view front camera
Press once = Back to OEM screen
Press for 2 seconds = Force view rear camera
(only if aermarket camera is used)
Press once = Back to OEM screen
For MyLink IO5/IO6 radios:
VEHICLE APPLICATIONS:
Compable with 8” CUE or MyLink IO5/IO6 Systems.
8” Screen
Buick
2014-2018
Cadillac
2013-2018
2014-2018
2014-2018
2014-2018
2015-2018
2013-2018
2013-2018
2016-2018
LaCrosse
ATS
CTS Coupe
CTS
CTS-V
Escalade
SRX
XTS
XT5
Chevrolet
2014-2018
2017-2018
2015-2018
2015-2018
2014-2018
2015-2018
2014-2018
2015-2018
2015-2018
Avalanche
Colorado
Corvee
Cruze
Impala
Malibu
Silverado
Suburban
Tahoe
GMC
2017-2018
2015-2018
2014-2018
2014-2018
Acadia
Canyon
Sierra Pickup
Yukon
OPERATION:
To enter Smart-Play mode, press
the upper le corner of the screen
or double click the HOME buon.
Smart-Play home screen. Use
the factory touch screen for
Smart-Play controls.
Apps can be opened by touch
screen or by Siri control.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
Crux ACPGM-80N seamlessly integrates Android Auto and CarPlay into your compatible GM vehicle's infotainment system, allowing you to connect your smartphone and access your favorite apps, music, and navigation directly from your car's display. It also adds front and rear camera inputs, maintaining the functionality of your original backup camera and displaying the front camera automatically when shifting from reverse to drive.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Connects2 CTSIV006.2 Installation guide
-
Mercedes-Benz NTG 5.5 / 6 / MBUX Camera Video Interface User manual
-
Axxess AXSSO-GM2 Installation guide
-
-
Nav TV NNG-GM2 Installation Instructions Manual
-
Jensen SOOGM-16 User manual
-
PAC NU-GM51 User manual
-
BrandMotion 9002-2764V2 Installation guide
-
Cadillac CADNAV1 Installation guide
-
NavLinkz RL2-N900 Installation guide