Thanks for choosing KC HiLiTES products; your satisfaction is very important to us. if you have any questions

regarding this product or any other KC HiLiTES products, please contact us at (888) 689-5955 or visit kchilites.com.

PARTS INCLUDED

1 - 50” LED light bar with wiring

1 - Above windshield light mounting bracket set

10 - M8 x 1.25 x 30 mm Black Zinc Bolts

10 - M8 Black Zinc Washers

2 - Protective Rubber Gaskets

MOUNTING THE BRACKETS

of scotch tape or similar.

3. Place the bracket on the gasket and start each of the

five M8 bolts and washers. Tighten all by hand.

Remove the tape used to secure and then tighten all

4. Repeat procedure for opposite side of vehicle.

5. Install your 50” C50 LED bar to the brackets and wire

it according to the instructions included with the LED

bar.

YOU’RE DONE