Equilibrium Credenza Installation Guide – Revision B – 1/08/20
EQUILIBRIUM CREDENZA
INSTALLATION GUIDE
UNIVERSAL SUPPORT FURNITURE
EI0006
EQUILIBRIUM END USER AGREEMENT
WARNING AND INDEMNITY AGREEMENT
Enwork Equilibrium Credenza bases must be installed directly into a four inch
Failure to install on four inch thick concrete oor or failure to follow installation instructions
may cause table to function improperly and could lead to personal injury and or structural
damage. Do not, under any circumstance, install on a concrete oor less than four inches thick.
Equilibrium Credenza assembled can weigh over 400 pounds (unloaded) supported in 0.167
square foot area. It is the responsibility of the dealer to verify that the location for Equilibrium is
suitable and is properly installed. End user agrees that the installation shall not be modied as
the location of the table base shall not be moved without assistance from an Enwork Dealer.
It is the responsibility of the dealer and end user to adhere to and follow any local or state
building, electrical and accessibility codes.
Enwork is not responsible for any structural failures or personal injuries or property damage
due to improper installation or improper use of product. End user agrees to defend, indemnify
and hold harmless Enwork from any claims of any nature or type arising out of unauthorized
modication or movement of the table base or any other improper use of the product.
Note:
Specications subject to change without notice.
Rev 01.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331
INSTALLATION GUIDE
1) TOOLS AND SUPPLIES REQUIRED
Adjustable Wrench
Drill/Hammer Drill
Socket Wrench
Vacuum
Level
Square Drive
Utility Knife
INSTALLATION GUIDE
2) PARTS AND FASTENERS INCLUDED
Credenza Base
Aluminum Shim (Pack) Removeable Cover
INSTALLATION GUIDE
3) ASSEMBLY: INSTALLING THE BASE
FIGURE 3
Note: Check that base is oriented as desired
the base location
Note: Hold the marker vertically and spin the marker
around the hole to get the best result.
INSTALLATION GUIDE
3) ASSEMBLY: INSTALLING THE BASE CONT. I
INSTALLATION GUIDE
3) ASSEMBLY: INSTALLING CREDENZA
INSTALLATION GUIDE
3) ASSEMBLY: INSTALLING CREDENZA CONT. I
Screws (SCREW1)
Note: If power routing is required, please proceed to following
steps for routing diagram.
Specications subject to change without notice.
Rev 01.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331
/
