2. Enwork
  3. Screens

Enwork Screens Installation guide

  • Hello! I've reviewed the installation instructions for the ENWORK Privacy Panel All-In-One. This document outlines the steps for assembling and installing the privacy panel, emphasizing the importance of handling the acrylic screens with care to avoid scratches. I am ready to assist with your questions about the document.
  • What kind of screws are used to attach the brackets?
    What should be done if acrylic screen's protective film is removed?
    What type of screws are used to attach the assembly to the top?
All-In-One Privacy/Modesty Panel Installation Instructions
ALL-IN-ONE PRIVACY/MODESTY
PANEL INSTALLATION INSTRUCTIONS
ACCESSORIES
TI0035
WARNING:
Acrylic screens scratch and scuff easily. After removing
protective lm, immediately and carefully install the screen.
DO NOT remove protective lm from acrylic screens, then stack
them in a pile or against each other. Experience shows this will
cause marring and scratching.
INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
2) TOOLS AND SUPPLIES REQUIRED
1⁄4-20 x .5” Phillips Panhead Bolt #10– 1” Square Drive Panhead Phillips EM-1332
Drill Square Driver Bit
INSTALLATION GUIDE
3) ASSEMBLY: ALL-IN-ONE PRIVACY/MODESTY
Place the Privacy/Modesty Panel on a at surface.
Install the EM-1332 brackets with the .5” Panhead bolts.
Screw the entire assembly into the top using the
#10-1” screws.
FIGURE 1
FIGURE 2
FIGURE 3
Specications subject to change without notice.
Rev 02.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331
/