2. Enwork
  3. Wall-Mounted Tapered

Enwork Wall-Mounted Tapered Installation guide

  • Hello! I've reviewed the ENWORK Wall Mounted Tapered Credenza Installation Guide. This document covers the assembly and installation of the WML20xxAx and WMLB20xxAx credenzas, including mounting bracket details, wall support requirements, and step-by-step instructions. I'm ready to assist you with any questions about the installation process or product specifications outlined in the guide.
  • How many people are required for assembly?
    How much weight must the wall support per linear foot?
    What should I check before Installation?
    Where should the bottom LZCLEET bracket be located for a 31" top height credenza?
Wall Mounted Tapered Credenza Installation Guide – Revision A
WALL MOUNTED TAPERED
CREDENZA INSTALLATION GUIDE
UNIVERSAL SUPPORT FURNITURE
EI0007
INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
2) TOOLS AND SUPPLIES REQUIRED
WML20xxAx
WMLB20xxAx
Note: Dealer/Installer must determine wall construction and provide appropriate wall anchors to secure LZCLEET brackets
Drill
LZCEET30
Level
#10-1.25 Phillips Flat Head Screw
Phillips Bit Tape Measure
INSTALLATION GUIDE
3) ASSEMBLY OVERVIEW:
FIGURE 3.1
Before Beginning Installation:
- Number of people required for assembly: 2
- The architectural wall must be able to support 100 pounds of weight per linear foot of credenza.
(i.e. 6’ Credenza = 600 pounds of support)
- Determine wall construction and use appropriate wall anchors to secure LZCLEET brackets to wall.
- Read all instructions prior to beginning installation
3.1.1) Attach LZCLEET brackets to back of credenza using
#10 x 1.25” Wood Screws as shown in Fig 3.1.
Note: See detail for bracket orientation.
INSTALLATION GUIDE
3) ASSEMBLY OVERVIEW: CONT. I
3.2.1) Install LZCEET brackets to wall. For a wall mounted tapered credenza with a top height of 31”, your bottom LZCLEET
bracket should measure 16.3” from the oor to the center of the mounting hole.
3.2.2) Secure bottom LZCLEET bracket to the wall, ensuring that it is level.
Note: For Buffet Height, Refer to Fig 3.3 on the next page
3.2.3) Locate and install the upper LZCLEET brackets to wall. (Refer to Credenza bracket spacing page for dimensions)
3.2.4) Place the credenza onto the LZCLEET brackets.
Note: If the wall is not plumb, it will make it difcult to engage the LZCLEET brackets. It may be necessary to shim the
Z-brackets on the wall.
FIGURE 3.2
*Measurement to center of hole
for wall mounter LZCLEET30
INSTALLATION GUIDE
4) BUFFET HEIGHT CREDENZA BRACKET SPACING
FIGURE 3.3
*Measurement to center of hole
for wall mounter LZCLEET30
INSTALLATION GUIDE
5) CREDENZA BRACKET SPACING OVERVIEW
60”W
72”W
84”W & 96”W
INSTALLATION GUIDE
6) CROSS SECTION OF INSTALLATION
Credenza
Credenza Mounted Bracket
Wall Mounted Bracket
Drywall
Stud
Specications subject to change without notice.
Rev 04.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331
/