BLOTZ B28-SFW-201 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Stand-alone Consoles model kit. This document provides step-by-step guidance on how to assemble your 28mm scale Sci-Fi wall system. It details the necessary tools and materials, and how to assemble each components. I am ready to answer any questions you might have about the assembly process or the product itself.
  • What type of glue is required?
    What tool is required to remove sections from the sprue?
    What can be used to hold the pieces in place while the glue dries?
28mm Sci-Fi Walls Stand-alone Consoles
B28-SFW-201
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Each console is formed from the pieces shown
above.
Glue the light bar between the two uprights, with the
detail facing downwards and glut the uprights to the
base.
Add the screen, keyboard and lower panel as
shown above.
Attach the two back panels.
The completed consoles.
/