5019 100 75084
DA 805
1.
Control panel.
2.
Grease filters (behind the extractor grille).
3.
Lighting unit.
4.
Pull-out steam deflector.
5.
Steam deflector pivot (inside the extractor
hood, at the two sides of the steam deflector).
REMOVING AND REPLACING OR
WASHING THE GREASE FILTER - Fig. 1
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extractor grille (
b, c
).
4.
Remove the grease filter fixing device (
d
)
5.
Remove the dirty grease filter.
6.
After replacing ot washing the grease filter
remount in reverse order (depending on the
model), making sure the entire extraction
surface is covered.
REPLACING BULBS - Fig. 1
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extractor grille (
b, c
).
4.
Remove the burn-out bulb and fit a new one.
Use 40W max E14 bulbs only.
5.
Remount the extraction grille.
FITTING OR REPLACING THE CARBON
FILTER - Fig. 2
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extractor grille (
b, c
).
4. Fitting:
fit the carbon filter over the motor
protection grille inside the reference pins (
f
) -
the reference mark (
g
) on the edge of the
carbon filter should line up with the arrow on
the fan shroud (
h
). Turn clockwise.
Removing:
Turn anti-clockwise.
5.
Remount the extraction grille.
CONTROL PANEL
A.
Speed selector.
B.
Light switch.
1
4
2
3
a
5
b
c
d
b
d
Fig. 1
large amount
of steam and fumes
medium amount
of steam and fumes
small amount
of steam and fumes
AB
Fig. 2
g
h
f
PRODUCT DESCRIPTION SHEET
F NL E PGBD GRI
