Whirlpool AKR 930 WH User guide

Whirlpool
Brand
Whirlpool
Model
AKR 930 WH
Category
Cooker hoods
Type
User guide

This manual is also suitable for

AKR 433-444-453
AKR 464-466-467
5019 100 75176
INSTALLATIONSANGEBEN UND ALLGEMEINE HINWEISE
Mindestabstand zur Kochfläche: 60 cm (Elektroplatten), 70 cm (Gas-, Öl- oder
Kohlekochplatten). Das Gerät darf erst nach erfolgter Installation an die
Stromversorgung angeschlossen werden. Sollte eine unzugängliche Steckdose
verwendet werden, ist ein normgerechter, zweipoliger Schalter mit einer
Kontaktöffnungsweite von mindestens 3 mm in einer leicht zugänglichen
Position anzubringen. Das Auslassrohr (13 A) wird nicht mitgeliefert und muss
gesondert erworben werden.
Achtung!
Bei allen Modellen aus Edelstahl mit direkt außen angebrachtem Fettfilter kann
das Absauggitter nicht entfernt werden. Alle Wartungs- und Montagearbeiten, bei
denen ein Zugang zum Inneren der Dunstabzugshaube benötigt wird, können
unmittelbar nach Entfernung des Fettfilters vorgenommen werden. Es folgt eine
Liste der betreffenden Modelle:
AKR 444 22030 IX, AKR 453 15040 IX, AKR 453 10030 IX, AKR 464 01030 IX,
AKR 467 29030 IX, AKR 466 01030 IX.
INSTALLATION SHEET AND GENERAL RECOMMENDATIONS
Minimum height above cooker: 60 cm (electric cookers), 70 cm (gas, gas-oil or
coal cookers). Do not connect the appliance to the electrical power supply until
installation is completed. If the plug is not easily accessible once inserted into the
socket, a two-pole switch with minimum break distance between contacts of 3
mm must be fitted at an easily accessible point. The exhaust pipe is not supplied,
and should be bought separately.
Warning!
In the stainless steel models with grease filter mounted externally it is not
possible to remove the extraction grille. To carry out fitting and maintenance
operations inside the hood remove the grease filters only. This applies to the
following models:
AKR 444 22030 IX, AKR 453 15040 IX, AKR 453 10030 IX, AKR 464 01030 IX,
AKR 467 29030 IX, AKR 466 01030 IX.
FICHE D'INSTALLATION ET RECOMMANDATIONS GÉNÉRALES
Distance minimale par rapport à la cuisinière : 60 cm (cuisinière électrique), 70 cm
(cuisinière à gaz, mazout ou charbon). Ne branchez pas l'appareil tant que
l'installation n'est pas terminée. S'il s'avère difficile d'accéder à la prise de
courant une fois qu'elle a été insérée dans la fiche, installez un interrupteur
bipolaire conforme facilement accessible ayant une ouverture minimale de 3 mm
entre les contacts. Le tuyau d'évacuation n'est pas fourni avec l'appareil et doit
être acheté à part.
Attention!
Pour tous les modèles INOX dont le filtre à graisses est monté directement à
l'extérieur, il n'est pas possible d'extraire la grille d'aspiration. Toutes les
opérations de montage et d'entretien nécessitant l'accès à l'intérieur de la hotte
doivent être réalisées uniquement en retirant les filtres à graisses. Voir liste des
modèles ci-après :
AKR 444 22030 IX, AKR 453 15040 IX, AKR 453 10030 IX, AKR 464 01030 IX,
AKR 467 29030 IX, AKR 466 01030 IX.
INSTALLATIEKAART EN ALGEMENE WAARSCHUWINGEN
Minimumafstand tot het kooktoestel: 60 cm (elektrische kooktoestellen), 70 cm
(kooktoestellen op gas, olie of kolen). Geef het apparaat geen stroom totdat de
installatie geheel voltooid is. Als de stekker, wanneer hij in het stopcontact
gestoken is, zich niet op een toegankelijk punt bevindt, moet hoe dan ook een
genormaliseerde tweepolige schakelaar worden gemonteerd met een afstand
tussen de contacten van minstens 3 mm, die goed toegankelijk is. De
afvoerleiding wordt niet bijgeleverd en dient aangeschaft te worden.
Attentie!
Bij alle roestvrij stalen modellen met een vetfilter die rechtstreeks aan de
buitenkant gemonteerd is, is het niet mogelijk het ventilatierooster te verwijderen.
Alle montage- en onderhoudswerkzaamheden waarbij het noodzakelijk is
toegang te krijgen tot de binnenkant van de kap, dienen uitgevoerd te worden
door alleen de vetfilters te verwijderen. Hieronder vindt u de lijst van deze
modellen weergegeven:
AKR 444 22030 IX, AKR 453 15040 IX, AKR 453 10030 IX, AKR 464 01030 IX, AKR
467 29030 IX, AKR 466 01030 IX.
D
GB
F
NL
75176.fm5 Page 1 Tuesday, June 6, 2000 12:22 PM
Page is loading ...
AKR 433-444-453
AKR 464-466-467
5019 100 75176
Entfernen Sie das Schaumstoffstück vom hinteren
Luftauslass!
Remove the sponge from the rear outlet!
Retirez la mousse du dispositif
d'évacuation arrière!
Verwijder de spons uit de afvoer aan de
achterkant!
Quite la esponja de la descarga posterior!
Retire a esponja do despejo posterior!
Rimuovere la spugna dallo scarico
posteriore!
ú202 13 #!.)2 1& ...&"
(F) Umluftversion
(F) Filter Version
(F) Version Filtrante
(F) Model met luchtcirculatie
(F) Versión filtrante
(F) Versão Filtrante
(F) Versione Filtrante
) 2 0..*&1
Kohlefilter
Carbon filter
Filtre au charbon
Koolstoffilter
Filtro de carbón
Filtro de carbono
Filtro al carbone
-2! 00! *
!..
Dunstabzugsversion (A)
Extractor version (A)
Version aspirante (A)
Model met luchtafvoer naar
buiten (A)
Versión aspirante (A)
Versão aspirante (A)
Versione Aspirante (A)
 2 0..&2 #
.!.$
75176.fm5 Page 3 Tuesday, June 6, 2000 12:22 PM
Page is loading ...
AKR 433-444-453
AKR 464-466-467
5019 100 75176
1. Control panel
2. Grease filter (positioned behind the extraction
grille, or fitted externally)
3. Lighting unit
Note! The AKR 467 model is designed for use
with 2 x 20W halogen bulbs.
REMOVING AND WASHING THE
GREASE FILTERS:
1. Unplug the appliance or disconnect the mains
power supply.
2. For models with the grease filter located
behind the extraction grille:
-
Open the extractor grille.
-
Press the buttons
(Fig. 1a-b-c, Fig. 2d)
to
release the grille, all the time supporting it to
prevent it from falling.
-
Remove the device securing the grease filter
(Fig. 3e, Fig. 4f)
.
-
Remove the dirty grease filter
(Fig. 4g)
.
For models with the grease filter located
externally:
-
Pull the handles back
(Fig. 5h)
, and then
downwards
(Fig. 5i)
.
3. After cleaning the grease filter refit in reverse
order, making sure the entire extraction
surface is covered. Wash the extraction grille
(where provided) with hot soapy water.
CONTROL PANEL
AKR 433 - 444
A. Light ON/OFF
switch.
B. Rotating switch for
extraction speed
selection, 3 settings
for model AKR433, 3
settings plus
intensive speed for
model AKR444.
AKR 453 - 464
AKR 466 - 467
C. Light ON/OFF switch
(models AKR453 and
AKR464 feature two
light functions:
Soft light: press once.
Bright light: press
twice.
Press again to switch
off the light.
D. Motor ON/OFF
switch.
E. Extraction speed
increase button, 3
settings for model
AKR453, 3 settings
plus intensive speed for
models AKR464-466-
467.
F. Extraction speed
decrease button.
d
FIG. 1
FIG. 2
FIG. 5
FIG. 3
FIG. 4
PRODUCT DESCRIPTION SHEET
F NL E PGBD IGR
75176.fm5 Page 7 Tuesday, June 6, 2000 12:22 PM
5019 100 75176
AKR 433-444-453
AKR 464-466-467
Active carbon filter maintenance:
The active carbon filter for this unit is made of
a spongy material, and should be washed
every two months under normal working
conditions.
Wash the carbon filter by hand or in a dishwasher
at 65°C using a suitable detergent (be careful not
to damage its cloth covering). Gently remove
excess water, then dry in an oven at a constant
temperature of 100°C for 10 minutes.
The filter can be washed together with the plastic
frame which secures it in place.
The carbon filter needs renewing every two
years.
1. Unplug the appliance or disconnect the mains
power supply.
2. Models with extraction grille :
-
Open the extractor grille.
-
Press the buttons
(Fig. 1a-b-c, Fig. 2d)
to
release the grille, all the time supporting it to
prevent it from falling.
- Fitting:
Fit the active carbon filter
(Fig. 6j)
over the extraction grill
(Fig. 6k
- bayonet
fitting), the arrow
(Fig. 6l)
printed on the
carbon filter should align with the arrow on the
fan shroud
(Fig. 6m)
. Turn clockwise.
- Removing:
Turn the active carbon filter anti-
clockwise to release it from its seat.
Models with an external grease filter :
-
Open the grease filters.
-
Push the handles back
(Fig. 5h)
, and then
downwards
(Fig. 5i)
.
-
Fit the rectangular active carbon filters over
the rear section of the grease filters and
secure them in place using the four small
metal rods (two per filter) supplied with the
carbon filters
(Fig. 7)
.
3. Refit the extractor grille.
Replacing bulbs
(AKR433-444-453-464-466)
1. Unplug the appliance or disconnect the mains
power supply.
2. Open the extractor grille.
Press the buttons (Fig. 1a-b-c, Fig. 2d) to
release the grille, all the time supporting it to
prevent it from falling.
3. Remove the burnt-out bulb.
Replace using 40W max. E14 bulbs (Fig. 8)
or 11W PL bulbs only (Fig. 9).
4. Refit the extractor grille.
Replacing the halogen bulbs
(only AKR 467)
1. Unplug the appliance or disconnect the mains
power supply.
Using a screwdriver or any other suitable tool,
prise off the lamp cover (Fig. 10).
2. Remove the burnt-out bulb.
Replace using 20W max. halogen bulbs only,
(Fig. 10) taking care not to touch them with
your hands.
3. Replace the lamp cover so that it clicks into
position.
FIG. 6
FIG. 7
FIG. 8
FIG. 9
FIG. 10
k
J
l
m
F NL E PGBD IGR
75176.fm5 Page 8 Tuesday, June 6, 2000 12:22 PM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Whirlpool AKR 930 WH User guide

Whirlpool
Brand
Whirlpool
Model
AKR 930 WH
Category
Cooker hoods
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents