Whirlpool AKR 631 AL Program Chart

Brand: Whirlpool

Model: AKR 631 AL

Category: Cooker hoods

Type: Program Chart

This manual is also suitable for

AKR 631 IX WP

5019 318

33110

AKR 631 - AKR 948 - AKR 952



INSTALLATIONSANGABEN

Mindestabstand zur Kochfläche: 50 cm (Elektroplatten), 75 cm (Gas-, Öl-,

Kohlekochplatten). Folgen Sie bei der Installation der Nummerierung (1

.....).

Schließen Sie das Gerät erst nach erfolgter Installation an die Stromversorgung an.

Achtung! Das Auslassrohr und die Befestigungsmanschetten (15) sind nicht im

Lieferumfang inbegriffen und müssen gesondert erworben werden.

INSTALLATION SHEET

Minimum height above cooker: 50 cm (electric cookers), 75 cm (gas, gas oil or coal

cookers). To install follow points (1

.....). Do not connect the appliance to the

electrical power supply until installation is completed. Warning! The exhaust pipe and

clamps (15) are not supplied and must be bought separately.

FICHE D'INSTALLATION

Distance minimale par rapport à la cuisinière : 50 cm (cuisinière électrique), 75 cm

(cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la numérotation

.....). Ne branchez pas l'appareil tant que l'installation n'est pas terminée.

Attention ! Le conduit d'évacuation et les colliers de fixation (15) ne sont pas fournis

et doivent être achetés à part.

INSTALLATIEKAART

Minimumafstand tot het kooktoestel: 50 cm (elektrische kooktoestellen), 75 cm

(kooktoestellen op gas, olie of kolen). Volg voor de montage de nummering

.....). Geef het apparaat geen stroom totdat de installatie geheel voltooid is.

Let op de afvoerbuis en de klembanden (15) worden niet bijgeleverd en moeten apart

worden aangeschaft.

FICHA DE INSTALACIÓN

Distancia mínima desde los quemadores: 50 cm (fuegos eléctricos), 75 cm (fuegos de

gas, gasóleo o carbón). Para el montaje, siga la numeración (1

...). No conecte

el aparato a la corriente eléctrica hasta que la instalación esté completamente

finalizada. ¡Atención! El tubo de descarga y las abrazaderas (15) no están incluidas y

se compran aparte.

FICHA DE INSTALAÇÃO

Distância mínima dos fogões: 50 cm (fogões eléctricos), 75 cm (fogões a gás, óleo ou

carbono). Para montar siga a numeração (1

.....). Não ligue o aparelho à

corrente eléctrica até a instalação estar concluída. Atenção! O tubo de descarga e as

tiras de fixação (15) não são fornecidas e devem ser compradas à parte.

SCHEDA INSTALLAZIONE

Distanza minima dai fuochi: 50 cm (fuochi elettrici), 75 cm (fuochi a gas, gasolio o

carbone). Per il montaggio seguire la numerazione (1

.....). Non dare corrente

all’apparecchio finché l’installazione non è totalmente completata. Attenzione! Il tubo

di scarico e le fascette di fissaggio (15) non sono fornite e vanno acquistate a parte.

ùüùü+ùùùþ

ü$12.)12.1.)2"0120"FP02!"0120"FP0120"

.0! #02!0. #0! # +.22  21.  #1202

.!1

2! 3 / 2020002!)!0*.21#10#!

2  !&12"0.212.1"! 1 $1&."..&".2.

 !.120!&1"/0/.202..!0.. 2 *$&!12

31833110.fm Page 1 Friday, December 19, 2003 9:54 AM

5019 318

33110

AKR 631 - AKR 948 - AKR 952



AKR 952

31833110.fm Page 2 Friday, December 19, 2003 9:54 AM

5019 318

33110

AKR 631 - AKR 948 - AKR 952



Preliminary information for installing the hood:

Disconnect the power supply at the domestic main switch before carrying out electrical connections.

Place the extraction unit on a flat surface and fit the bottom part of the hood on it

(remove the grease filter/s).

Carry out the electrical connections between the two parts.

Fix the hood to the extraction unit with 10 screws.

Using a pencil, draw the centre line on the wall up to the ceiling to facilitate installation operations.

Attach the hole diagram to the wall: the vertical centre line printed on the hole diagram must match the

centre line drawn on the wall, and the lower edge of the hole diagram must match the lower edge of the

hood: remember that with installation completed the bottom of the hood must be at least 50 cm above the

cooktop in case of electric cookers and 75 cm in case of gas or mixed cookers.

Place the support bracket on the hole diagram so that it matches the dashed rectangle, mark the two

external holes and drill, remove the hole diagram, insert 2 wall plugs and fix the hood support bracket with

two 5x45 mm screws.

Hook the hood to the bracket.

Adjust the distance between the hood and the wall.

Adjust the hood horizontally.

10.

From the inside of the hood, mark the two holes for fixing the hood.

11.

Remove the hood from the bracket.

12.

Drill on the marks (Ø 8 mm - see step 10).

13.

Insert 2 wall plugs.

14.

Fit the flue support bracket

to the wall and against the ceiling, use the support bracket as hole diagram

(the small slot on the support must match the line drawn on the wall - step 4) and mark 2 holes with the

pencil, drill the holes (Ø 8 mm), and finally insert 2 plugs.

15.

Fix the flue support bracket to the wall with two 5x45 mm screws.

16.

Hook the hood to the bottom bracket.

17.

Fix the hood with two 5x45 mm screws (ABSOLUTELY NECESSARY).

18.

Connect an exhaust pipe (pipe and clamps are not supplied and must be bought separately) to the collar

located above the extraction motor unit.

For extractor operation, connect the other end of the exhaust pipe to the home discharge device. For filter

operation, fix the deflector

to the flue support bracket

(model

AKR 948-631

with 4 screws - model

AKR 952

with 2 screws) and connect the other end of the exhaust pipe to the deflector collar

(if the

collar is not already fitted it should be inserted on the deflector and secured with 1 screw). Once the steam

and fumes have been filtered by the carbon filter (not provided, to be ordered separately) they are

conveyed back to the kitchen through grid

19.

Carry out the electrical connection.

20.

Apply the flues and fix them with 2 screws (

20a

) to the flue support

(

20b

21.

Slide the bottom section of the flue in the special seat above the hood to completely cover the extraction

unit.

22.

(model

AKR 952

only): fix the bottom section of the flue to the hood with two 3x9 screws.

Refit the grease filter/s and check for correct hood operation.

INSTALLATION - ASSEMBLY INSTRUCTIONS

D F NL E

P I GR

31833110.fm Page 5 Friday, December 19, 2003 9:54 AM

5019 318

33110

AKR 631 - AKR 948 - AKR 952



D F NL E

P I GR

Control panel.

Grease filter.

Halogen bulbs.

Steam deflector.

Telescopic flue.

To clean the grease filter

Wash the grease filter at least once a month.

Disconnect the electrical power supply.

Remove the grease filters -

Fig. 2

: pull the spring

release handle

(f)

downwards, then remove the

filter.

After cleaning the grease filter refit in reverse

order, making sure the entire extraction surface is

covered.

Carbon filter Fitting and Maintenance

Fitting the carbon filter:

Disconnect the electrical power supply.

Remove the grease filter

(f - Fig. 2)

Turn the side knobs 90° and then remove the

filter holder

(g - Fig. 3)

Fit the carbon filter

(h - Fig. 3)

in the filter holder

(i - Fig. 3)

Refit the filter holder and secure it to the hood

with the screw

(g - Fig. 3)

Refit the grease filter.

Carbon filter maintenance:

Unlike traditional carbon filters, this carbon filter can

be washed and reactivated.

With normal hood use, the filter should be cleaned

once a month. The best way to clean the filter is in a

dishwasher at the highest temperature possible, using

a normal dishwasher detergent. To avoid particles of

food or dirt settling on the filter during washing and

giving rise to unpleasant smells, it is advisable to wash

the filter on its own. After washing, dry the filter in the

oven at 100° C for 10 minutes to reactivate it.

The filter will retain its odour-absorbing capacity for

three years, after which it must be replaced.

Replacing bulbs

Disconnect the electrical power supply.

Use a small screwdriver or any other suitable tool

to prise off

(m-Fig. 4)

the lamp cover

(p-Fig. 4)

Remove the burnt-out bulb.

Replace using 20 W max halogen bulbs only,

making sure not to touch them with your hands.

Close the lighting unit (snap-close).

CONTROL PANEL

Light ON/OFF switch.

ON/OFF and speed 1 selector switch

(small amount of steam and fumes).

B+D.

Speed 2 selector switch

(medium amount of steam and fumes).

B+D.

Speed 3 selector switch

(large amount of steam and fumes).

Fig. 1

Fig. 4

Fig. 2

Fig. 3

PRODUCT SHEET

31833110.fm Page 6 Friday, December 19, 2003 9:54 AM

Whirlpool AKR 631 AL Program Chart

Brand: Whirlpool

Model: AKR 631 AL

Category: Cooker hoods

Type: Program Chart

This manual is also suitable for

AKR 631 IX WP

Download PDF

report

Whirlpool AKR 631 AL Program Chart

This manual is also suitable for

Whirlpool AKR 631 AL Program Chart

Related papers

Other documents