2. Home
  3. Lighting
  4. Mood lighting
  5. ITC
  6. 791X-FF-KKKK
791X-FF-KKKK

ITC 791X-FF-KKKK User manual

  • I've reviewed the provided installation instructions for the ITC Spreader Light 791X-FF-KKKK. This document outlines the necessary steps for safely mounting and wiring the light, as well as how to cycle through its color and brightness settings. I'm ready to assist with any questions you might have regarding the spreader light or the instructions themselves.
  • How do I change the color and brightness of the light?
    What is the recommended fuse protection?
    What hole size is needed for surface mount version 1?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
1. Surface Mount Version:
• Determine the installation location for your light and cut a 3-⅞”W x 1-⅜”H hole.
• Mark the screw holes and pre-drill.
• Wire the light using the wiring diagram below and test before finishing the install.
• Screw the light in place.
• Snap bezel onto light.
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY
FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• It is recommended that fuse protection be added to the positive (+) input.
3. Wire the light following the wiring diagram.
OPERATING INSTRUCTIONS
• Turn power on and then off again to toggle through the different colors and brightness
levels. Brightness/color levels will be as follows:
PARTS/TOOLS NEEDED:
Spreader Light Mounting Screws
(not provided)
Jigsaw
(not provided)
Power Drill
(not provided)
Marine Grade
Connectors (not provided)
Color Option Cycle Order
6300K 30% white / full white
Blue/6300K 20% blue / full blue / 40% white / full white
Red/6300K 20% red / full red / 40% white / full white
2. Surface Mount Version:
• Determine the installation location for your light and mark the screw holes
• Install screws and drill a hole for the wiring.
• Wire the light using the wiring diagram below and test before finishing the install.
• Rotate the light onto the screws
+12V
Red (+)
Black (-)
Incoming
12V DC Power
Fuse
INSTALLATION INSTRUCTIONS
Spreader Light
Part#: 791X-FF-KKKK
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00200 • Rev A • 11/04/21
Page 1 of 1
/