2. Super Bright LEDS
  3. LPDBL-U1 Series
LPDBL-U1 Series

Super Bright LEDS LPDBL-U1 Series User manual

  • I have reviewed the user manual for the superbrightleds LED Panel Light series LPDBL-U1-22-SW3C-SP40 and LPDBL-U1-22-SW3C-SP50. The document provides installation, safety, and specifications information. The panel light features dimmable backlit LEDs, 0-10V dimming, and safety tabs. I am ready to answer your questions about the product.
  • What should I do regarding power during installation?
    What is the recommended operating temperature range?
    What is the IP rating?
Dimmable Backlit LED Panel Light
Important: Read all instructions prior to installation. LPDBL-U1 Series
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 08/03/2021
5yr
User Manual
1. Turn supply power to circuit o. If installing as a retrot, remove existing xture.
2. Open driver box and remove knockout(s) for wiring. Make electrical connections
using wiring diagram. Once complete, resecure driver box cover.
3. Select wattage and CCT using built-in switches on the driver box.
4. Bend out safety tab to be vertical,
then upper portion out 90 degrees.
It is recommended that a safety cable
be installed to anchor the xture as well.
5. Lay xture into T-grid.
Wiring Diagram
Safety and Notes
• Product should be installed and serviced in accordance with applicable national, state,
and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source and circuit
breakers are switched o before performing any installation or wiring procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the weight of the xture. Failure
to properly support xture may result in damage or injury, for which the manufacturer
does not assume responsibility.
Specications
LPDBL-U1-22-SW3C-SP40
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
Model LPDBL-U1-22-SW3C-SP40 LPDBL-U1-22-SW3C-SP50
Operating Temperature -4°–113° F (-20°–45° C)
IP Rating IP40
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Pink
Green
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Pink
Green
100–277 VAC Input
0–10 V Dimming
Installation
Firmly bend Safety Tabs
up and out
Safety Tab
Safety Tab
Fixture
T-Grid
NW
CW AC
B
Driver Box
Safety Tab
Fixture
T-Grid
NW
CW AC
B
Driver Box
Note: Tabs should secure light in
T-grid while still allowing reinstallation
of adjacent ceiling tiles.
/