2. Super Bright LEDS
  3. LPDBL Series

Super Bright LEDS LPDBL Series User manual

  • Hello! I've reviewed the user manual for the superbrightleds LPDBL series LED panel lights. This document provides instructions for the installation of the dimmable LED panel lights, including wiring diagrams and safety recommendations. I am ready to help answer your questions about these fixtures and their features.
  • What is the operating temperature range of the LED panel lights?
    What type of dimming is supported?
    Is a safety cable included with the product?
47.75in
1212.85mm
23.75in
603.25mm
1.61in
40.64mm
1.77in
44.96mm
2.46in
62.48mm
3/4 INCH CONDUIT
KNOCKOUT
23.75in
603.25mm
23.75in
603.25mm
1.77in
44.96mm
1.50in
37.97mm
2.12in
53.85mm
User Manual
Dimmable LED Panel Light
LPDBL Series
User Manual
Rev Date: V1 07/01/2019Rev Date: V1 07/01/2019
LPDBL Series
5yr
Dimensional Drawings
Dimmable LED Panel Light
Important: Read all instructions prior to installation.
LPDBL-40K24-50-S
LPDBL-xK24-50-S
LPDBL-xK22-40-S
Dimmable LED Panel Light
Important: Read all instructions prior to installation.
Rev Date: V1 07/01/2019
Recommended Accessories
Included Parts
Specications
1 - LED panel Light
• 0–10V Slide Dimmer (F019)
• 0–10V Knob Dimmer (A019)
Model LPDBL-xK22-40-S LPDBL-xK24-50-S
Dimmable 0–10 V
Operating Temperature -4°–113° F(-20°–45° C)
IP Rating IP20
Product Weight 4.45 lb (2 kg) 9.1 lb (4.1 kg)
LPDBL Series
Drop Ceiling Installation
Safety Information
• Product should be installed by a certied electrician in accordance with
applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source
and circuit breakers are switched o before performing any installation
or wiring procedures.
• Avoid looking directly into the light when illuminated.
• Failure to properly support the xture may result in damage or injury, for
which the manufacturer does not assume responsibility. A safety cable
is not included, but it is recommended that one be connected to grid clip
during installation.
Wiring Diagram
1. Turn supply power to circuit o. If installing as a retrot, remove existing xture.
2. Open driver box and remove knockout(s) for wiring. Make electrical connections
using wiring diagram. Once complete, resecure driver box cover.
3. Bend out safety tab to be vertical, then upper portion out 90 degrees.
It is recommended that a safety cable (included) be installed to anchor
the xture as well.
4. Lay xture into T-grid.
Note: Tabs should secure light in
T-grid while still allowing reinstallation
of adjacent ceiling tiles.
FIG 2
FIG 1
Safet Tab
Driver Box
Fixture
T-Grid
Firmly bend Safety Tabs
up and out
Safety Tab
User Manual
Black
L L
N N
GND GND
White
Green
+ +
– –
Purple
Gray/Pink
Black
White
Green
Purple
Gray
100–277 VAC
Supply
0–10 V Dimmer
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
/