NCR 7649-K454 Kit Instructions

Brand: NCR

Model: 7649-K454

Type: Kit Instructions

7649‐K454

RearCustomerLCDHinge

Assembly

KitInstructions

IssueA

Revision Record

Issue Date Remarks

A Nov 2011 First Issue

Introduction

ThiskitprovidesamountforintegratinganLCDCustomerDisplayontheNCR7649

terminal.ThefollowingLCDmodelsaresupported.

•NCR594312”LCD

•NCR59826.5”LCD

Thefollowingfeatureisalsorequiredtobepresentintheterminal.

• 7649‐K021:ExtendedI/ODaughterCard(providesthreeadditional12

VPowered

USBports)

Kit Contents

Therearethreedisplaycablesincluded.Usageisdisplaydependent.

30580

VGA Cable, Low Profile

497-0460488

USB to DC Cable

497-0473452

12V Powered USB Cble

497-0476857

Customer Display

Pole Support

497-0473263

Customer Display

Integration Pole

497-0473393

Swivel Mount

497-0443228

Screw, M4x10, Phil, PH (5943)

006-8608196

Screw, 6-32 x 5/16, Phil, PH (5982)

007-7000205

rew, 6-32 x 0.375, Phil, PH, Ext Washer

7-7000205

Installation Procedures

1. RemovetheFillerPlugfromtheholeintherearoftheterminalchassis.

Filler Plug

2. RemovetheRearCover.

a. PressUPonthetwolatchesonthebottomoftheunittoreleasethecoverfrom

thechassis.

b. Pivotthebottomofthecoveroutasshowntoremoveit.

30356

Rear Cover Latches

Rear Cover

30357

3. InstalltheSwivelMountonthebackoftheLCD(4screws).Becarefultousethe

correctscrews(seeKitContentssection).

4. InstalltheCustomerDisplayIntegrationPoleontotheLCDSwivelMount.

30379

Swivel Mount

30585

Customer Display Integration Pole

5. AlignholeinthepolewiththeslotintheSwivelMount.

6. InserttheDomePlugintotheholeinthepole.Thepluglockstheplastic

componentstogetherandprovidesdisplayrotationlimitations.

7. InstalltheCustomerDisplayPoleSupportintheholeintheterminalcabinet.

8. InstalltheCustomerDisplayAssembly

intotheterminal.

30388

Dome Plug

30389

Customer Display Pole Support

9. Connectthecables.

5943Display:

•ConnectthePoweredUSBCabletothe12VUSBconnectorsontheterminal

anddisplay.

•ConnecttheVGACabletotheVGAconnectorsontheterminalanddisplay.

5982Display:

•ConnectthePoweredUSBtoDCCabletothe12VUSBconnectoronthe

terminalandtothe

Powerconnectoronthedisplay.

•ConnecttheVGACabletotheVGAconnectorsontheterminalanddisplay.

10. ReplcetheRearCover.

30581

VGA

12V USB

30582

VGA

Power

30381

12 V USB Ports

VGA Port

NCR 7649-K454 Kit Instructions

NCR 7649-K454 Kit Instructions

NCR 7649-K454 Kit Instructions

Related papers

Other documents