2. BLOTZ
  3. B28-ME-212

BLOTZ B28-ME-212 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ 28mm Ancient City Walls - Damaged Wall model. This document details the assembly process, including gluing connectors, attaching the rear wall, walkway, end braces, and layering brick pieces. I'm ready to answer any questions you may have about constructing the model.
  • What type of glue is needed?
    What tool is needed to remove parts?
    How many sheets of parts are there?
    What do the A and B sheets make
28mm Ancient City Walls – Damaged Wall
B28-ME-212
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care
and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
There are 2 sheets marked “A” and two marked “B”. The two marked “A” make one wall piece, while “B”
contains the parts for the other wall piece.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports, then
attach the rear wall.
Glue the whole assembly to the base and add the
walkway.
Take the end braces.
Glue them to the model (see pic).
Each layer of bricks is made up of two pieces. One
with etched details and one which is blank.
This shows the first four layers (in order).
Glue them to the model.
Add the front wall pieces and strip.
The final three layers.
Glue these into place.
Repeat this process for the other wall section.
The finished model.
/