2. BLOTZ
  3. B15-ME-008

BLOTZ B15-ME-008 Assembly Instructions

  • I've reviewed the instructions for the Middle Eastern B15-ME-008 building model. This document provides a clear guide on assembling the miniature structure, from removing pieces from the sprue to placing the roof sections. It details the tools required, such as glue, a modeling knife and sandpaper, as well as techniques for holding pieces in place while they dry. Feel free to ask me any questions about the assembly process or the building itself.
  • What type of glue is required for assembly?
    What tool is needed to remove parts from the sprue?
    Are there any specific tools needed for cleaning the joints?
    Can the roof sections be glued on?
15mm Middle Eastern Building #8
B15-ME-008
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Middle Eastern Building #8 (B15-MW-008)
Remove the four tall walls and the base from the
sprue.
Glue the front and centre wall to the base as shown.
The add the side and rear walls.
Attach the three lower walls.
Remove the seven roof supports and the door
from the sprue.
Glue the door behind the opening and attach the
supports by pushing the lugs through the holes in the
walls so that they stick out as shown above.
Glue the trapdoor to the roof sections and place
(do not glue) them on top of the roof supports.
The finished building.
/