2. BLOTZ
  3. B00-RTG-902

BLOTZ B00-RTG-902 Assembly Instructions

  • I'm here to assist you with the Scoreboard B00-RTG-902 instructions. I've reviewed the document, which outlines the assembly process for the Guild Ball scoreboard model. It covers how to attach the score wheels, and other parts, also contains advice on necessary tools and glue. Feel free to ask me any specific questions you have while building your model.
  • What type of glue should I use?
    What tools are needed for assembly?
    Can I paint the score wheels?
Guild Ball Scoreboard
B00-RTG-902
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Scoreboard (B00-RTG-902)
Remove the back plate and score wheels from the
sprue. Carefully remove the axles from the centre of
the score wheels.
Glue the axles to the back plate using the guides
scored into the plate. Leave to dry.
If you wish to spray your score wheels, do this now
before they are fastened into the scoreboard.
Put the score wheels over the axles. (do not glue)
Glue the top piece into place, ensuring the score
wheels fit comfortably through the holes provided.
Then glue the front plate into place.
Attach the sides – making sure the score wheels go
through the slots.
Glue the scoreboard to its base.
Glue the “Home”, “Away”, “Score” and “Points” pieces
into place as shown.
/