Fantasy Football Scoreboard
B00-RT-405 / B00-RT-406
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Please Note: For our build we removed all the pieces except for the dials and edge sections from the sprue then used a
white spray paint (from about 30cm away) to get the effect you can see.
The larger version of the scoreboard (B00-RT-406) uses the same instructions, the pieces are just bigger.
Remove the back plate and six axles from the sprue.
Glue the axles into the holes on the back plate.
Place (do not glue) the dials over the axles. Note the
orientation of the dials (see the ‘1’ on each dial above).
Place (don’t glue) the front plate into place, making
sure the axles fit into the holes provided.
Glue the base place to the scoreboard.
Glue the edges on – best to do this in the numbered
sequence shown above.
Glue the “Home”, “Away”, “Score”, “Turn” and
“Reroll” pieces into place as shown.
Note – the “Turn” and “Score” signs are
interchangeable if you want the score to be at the top.
The Finished Scoreboard.
/
