2. Oxford Garden
  3. Siena Ottoman

Oxford Garden Siena Ottoman Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the OXFORD GARDEN SIENA SOTT Ottoman. The document includes a parts list, assembly steps using dowels and a hammer and notes about preparing the product for outdoor use. I'm ready to answer any questions you might have about assembling your ottoman.
  • What tools are needed for assembly?
    What should I do if I am placing the ottoman on concrete or tile?
    What is the order when assembling the ottoman?
15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331 f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20
SIENA OTTOMAN - SOTT
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
FINISHING ITEMS
Medium Grit Sandpaper
NOTE: If the furniture is going to be placed on a concrete or tile patio, it should first be rinsed well
to remove the sawdust that may cause some staining.
NOTE: A hammer (not provided) will be needed for the assembly of this ottoman.
Foot Rest
Quantity: 1
Leg Assembly
Quantity: 2
Dowels
Quantity: 8
A
Ver. 06.30.20
INSTRUCTIONS
STEP 1
On a clean flat surface, lay the leg assembly2 on its side
mortise holes facing up. Line up the foot rest , and insert
into the leg assembly.
STEP 2
Line up and place leg assembly onto those parts already
assembled.
Ver. 2019.8.10
2
A
STEP 3
With a hammer, drive 8 total dowels into the predrilled
holes on the front and rear of the leg assemblies . Insert
the tapered end of the dowels first. NOTE: The dowels
should be easily driven in flush. If there is strong resistance,
do not force the dowel. Sand to smooth off areas around
the dowel pins. Your ottoman is now ready to enjoy!
1
1
2
1
1
A
/