2. BLOTZ
  3. B28-SFW-301

BLOTZ B28-SFW-301 Assembly Instructions

  • Hello! I'm a chat assistant ready to help you with your BLOTZ Sci-Fi Wall 95mm Door #2. I've reviewed the assembly instructions, and I know it includes a detailed step-by-step process with images for constructing the wall as well as the door, which is made from separate pieces. I understand that the model requires glue, modeling knife and maybe some pegs for easier assembly and that it has etched details and hook connections. Feel free to ask any specific questions you have about this model.
  • What kind of glue is recommended?
    What tools are needed for assembly?
    Are there any precautions for using the knife?
28mm Sci-Fi Walls – 95mm Door #2
B28-SFW-301
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Each end of the wall is formed from the pieces
shown above.
Glue the two hooked pieces through the back plate,
ensuring the hooks all point in the same direction.
Take the base and one pair of side walls.
Glue the end wall and side walls to the base. Repeat
this for the other end of the model.
The two inner walls are made from these pieces.
Add the strips with the etched detail facing outwards.
Add these to the model as shown above.
Glue the “roof” into position.
Take the short strips
Glue them to the roof as shown.
Take the end plates.
Slide one over each set of hooks and glue into place.
The front plate.
Glue a front plate to each side of the model.
The door is formed from the pieces shown above.
Glue the girder panels on each side of the door,
ensuring the edges align. Leave to dry.
The two pieces of the model.
Place (do not glue) the door into the space in the
model.
/