2. BLOTZ
  3. B28-SFW-001

BLOTZ B28-SFW-001, B28-SFW-100, B28-SFW-900, B28-SFW-901 Assembly Instructions

  • Hello! I've reviewed the instructions for the 28mm Sci-Fi Walls, specifically the 95mm Wall #1 model. This document guides you through the assembly process, from preparing the end pieces to adding the final lid. I'm ready to answer any questions you have about building this Sci-Fi wall model.
  • What type of glue should I use?
    What tools are needed for assembly?
    Can I use flat ends instead of hooked ends?
28mm Sci-Fi Walls – 95mm Wall #1
B28-SFW-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Each end of the wall is formed from the pieces
shown above.
Glue the two hooked pieces through the back plate,
ensuring the hooks all point in the same direction.
Add the outer later.
Repeat this for the other end piece.
Glue the two ends to the base.
The base and “Lid” are the same.
Add the side walls.
Glue the “lid” into place.
Attach the outer wall decoration.
If you want a flat end rather than a hooked one, use
the two pieces shown above in place of the hooked
end section.
The completed wall.
/