2. BLOTZ
  3. B28-SFW-009

BLOTZ B28-SFW-009, B28-SFW-104 Assembly Instructions

  • Hello! I've reviewed the user manual for the Blotz 95mm Wall #4 Sci-Fi wall model. This document provides clear instructions on how to assemble the wall using provided pieces, glue, and a modeling knife. I am ready to help with any questions you might have about the assembly process or the model itself.
  • What kind of glue do I need?
    What tools are needed for assembly?
    What can be used to hold pieces together while the glue dries?
28mm Sci-Fi Walls – 95mm Wall #4
B28-SFW-009
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Each end of the wall is formed from the pieces
shown above.
Glue the two hooked pieces through the back plate,
ensuring the hooks all point in the same direction.
Add the outer later.
Repeat this for the other end piece.
Glue the two ends to the base.
The base and “Lid” are the same.
Add the side walls.
Glue the “lid” into place.
Attach the outer wall decoration.
Glue the pipe pieces into position.
If you want a flat end rather than a hooked one,
use the two pieces shown above in place of the
hooked end section.
The completed wall.
/