s@Simplex
4001-9810 Alarm Relay Module
Installation Instructions
The alarm relay module is an accessory for 4001 fire alarm systems. It contains four SPDT
relays rated at 2A. When used, the relays work as follows:
l
Relay Kl energizes when there is an alarm on Zone 1.
l
Relay K2 energizes when there is an alarm on Zone 2.
l
Relay K3 energizes when there is an alarm on Zone 3.
l
Relay K4 energizes when there is an alarm on Zone 4.
The module may be mounted in two ways:
0 If the 4001-9804 transient suppressor, -9808 zone disconnect, or -9807 transient
suppressor/zone disconnect boards are NOT being used, the module may be
mounted in the control panel as shown in Figure 1.
l
The module may be mounted externally in a six-gang box (supplied by others) as
shown in Figure 2.
Note: If mounting the board in the control panel, remove the relay board mounting bracket
and six-gang trim plate before installation.
USE MOUNTING
SCREWS FROM
BRACKETASSEYBLV
TO MOUNT BOARD
IN PANEL
FIGURE 1
I
Q 1989 Simplex Tlme Recorder Co., Gardner, Mass 01441-0001 U.S.A.
Technical Manuals Online! - http://www.tech-man.com