Hubbell TD06034E Installation guide

Type
Installation guide
FULL ROUND OVERLAPPING
GUY MARKER
INSTALLATION INSTRUCTIONS
2
©Copyright 2014 Hubbell Incorporated | www.hubbellpowersystems.com | Adjust-A-Grip Installation
Position Guy Marker so that top of Marker is
upward on the strand.
Note: the TOP end is located opposite of the
end with the zip tie.
Continue application by simultaneously
rotating and pushing Marker onto strand.
In new construction just slide Marker onto
strand, and then apply deadend.
Place the slit of the Marker on the strand.
Push the strand through overlap into center of
Marker as shown in Figure 2.
Continue rotating and pushing Marker onto
strand until strand is completely inside Marker,
and Marker can be freely moved up and down
strand.
STEP 1
STEP 3
STEP 2
STEP 4
3
Remove zip tie and insert zip tie strap through
the two slots.
Pull Marker down over deadend allowing
Marker to expand and conform to hardware
as required. Wrap zip tie strap around Marker
and hardware. Place the zip tie strap through
its self-locking tab. Pull tightly to secure
Marker.
STEP 5
COMPLETED INSTALLATION
STEP 6
©Copyright 2014 Hubbell Incorporated | www.hubbellpowersystems.com | Adjust-A-Grip Installation
©Copyright 2014 Hubbell Incorporated | www.hubbellpowersystems.com | Adjust-A-Grip Installation
Hubbell has a policy of continuous product improvement. Please visit hubbellpowersystems.com to confirm current design specifications.
H u b b e l l P o we r S y s te m s ( H P S) m a n u f a c t u r e s a w id e v a r i e t y o f t r a n sm i s si o n , d i st r i b u t i o n , s u b s ta ti o n , O E M , u n d e r g r o u n d a n d c o m m u n ic a t i o n s p r o d u c t s
used by utilities. HPS products are also used in the civil construction, transportation, gas and water industries. Our product line includes construction,
switching and protection products, hot line tools, insulators, arresters, pole line hardware, cable accessories, test equipment, transformer bushings,
connectors, grounding equipment and polymer precast enclosures and equipment pads.
TD_06_034_E
About Hubbell Power Systems:
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Hubbell TD06034E Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI