Gianni Industries GK1700 Series Installation guide

Type
Installation guide
Copyright All rights reserved. - - Published on 2016.12.290071KGMP© U
)3()2(
(4)
(1)
(70mm)
(28.5mm)
(3mm)
(36.6mm)
(43mm)
GK1700 Series Electric Strike Installation Instructions
Specifications
Voltages: 12 or 24 VDC,
3 to 6 VDC or 8 to 16 VAC Intermittent Duty
(Intermittent use: Not to exceed 10 seconds)
Current Draw: 280mA/12VDC, 140mA/24VDC
Operating Temperature: 14° to 120°F (-10° to 49°C)
Humidity: 0%~85% Non-Condensing
Latch Throw: 1/2" (13mm)
Keeper Width: 1-1/8” (28mm)
Cycle Test: 250,000+ cycles
Static Strength: 1,000 lbs (454 kg)
Strike Body: Zinc Alloy
Faceplate Finish:
GK1700-01 Series: US32D Brushed Stainless Steel
GK1700-02 Series: Silver
GK1700-03 Series: US40 Duronic (Dark Bronze)
Lock Mode: Fail-secure
Swing Door Direction: Inswing
Installation Instructions for Wood Door Application
Measure latch position Mark latch position line Drill and cut the frame
Connect the wires using the
crimp connectors, then test
the strike, ensure you give it
correct voltage
Note: Please ensure that there is no back pressure on the keeper from the latch. As with most strike this may cause the
strike to bind and malfunction. It could also cause undo pressure on the solenoid and eventual failure of the strike.
Electric Drill
Chisel
GK1700-02 /03 Series
Frame Applications
Hollow Metal Wood
Inswing
Inswing
Cylindrical Lock
GEM LS-2200 Door Latch
(Sold separately)
Compatible Locks
(69.8mm)
(54mm)
(28mm)
(28
.
5mm)
(2mm)
(22.3mm)
(26.5mm)
(43mm)
GK1700-01 Series
7/8”
1 1/16”
1 11/16”
1 1/8”
2 1/8”
2 3/4”
1 /16”
1 1/8”
(26.5mm)
1 1/16”
(22.3mm)
7/8”
(28mm)
1 1/8”
(54mm)
2 1/8”
2 3/4”
1 7/16”
1/8”
1
11/16”
1 1/8”
Place the wire inside the connector
and use pliers to press down on the
head of the connector evenly.
Installing the Crimp Connectors
  • Page 1 1

Gianni Industries GK1700 Series Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI