3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
1. Determine the installation
location for your light. Once
determined drill a 2” hole
using a hole saw.
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL IN-
STRUCTIONS.
*Disconnect power before installing, adding or changing any component.
*To avoid a hazard to children, account for all parts and destroy all packing materials.
PARTS/TOOLS NEEDED:
Hardtop Light Decorative Bezel Mounting Screws 2” Hole Saw Bit
(not provided)
Butt Splice Connectors
(not provided)
Power Drill
(not provided)
*Optional, predrill screw holes
2A. Feed wires back through
the hole and screw the light
in place using the screws
provided.
3. Attach the bezel by lining
up the cutouts and rotating
until it snaps in place.
*Follow wiring diagram below
before screwing light in place
2B. Wire the light following the wiring diagrams
below. The color sequence of the Tri color light
will be as follows: 3000K → Off → 4000K → Off →
6500K OR Red → Off → Blue → Off → 6500K | The
color sequence of the Bi color light will be as
follows: 3000K → Off → 6500K. If the light is off for
more than 30 seconds it will re-start the cycle.
*It is highly recommended that appropriate fusing be used.
+12V Red (+)
Black (-)
2B. Wire the light following the wiring diagrams
below.
Bi or Tri Color Wiring Diagram VersiColor RGBW Wiring Diagram
RGBW
Hardtop Light
RGBW
Controller
Black (+)
Blue (B)
Green (G)
Red (R)
12V DC (+)
Black (-)
Incoming
12V DC
Power
Fuse*
White (W)
INSTALLATION INSTRUCTIONS
Hardtop Light
Part#: 69670B-XX-KKKK
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00091 • Rev B • 11/18/19
Page 1 of 1
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Robus RC8CCT3-13 Product information
-
-
-
-
-
-
-
-
Robus RSN10040DAS4-04 Product information
-